Emerson Series 3000 MVD User Manual
Configuration and Use Manual
3
Before You Begin
Installation
Using the
Dis
p
la
y
Di
gi
gi
tal
Comm
Comm
un
ic
ic
atio
ns
Se
tu
p
Se
tu
p
Be
fo
fo
re
Y
Y
o
u
Begin
1.6
Communication tools
You can communicate with a Series 3000 device using any of the following communication tools:
•
The local display
•
ProLink II v2.5 and higher (ProLink II v2.9 or higher recommended), or Pocket ProLink v1.3
and higher
and higher
•
375 Field Communicator with the appropriate DD:
Micro Motion 3000 Mass flo v7 DD v2
or
higher
This manual focuses on the use of the local display. Detailed menu flowcharts for the local display are
provided in Appendix F.
provided in Appendix F.
For information on using ProLink II or the Communicator with a Series 3000 device, see Appendix G
or Appendix H. These appendices also provide flowcharts for the most commonly used menus and
procedures.
or Appendix H. These appendices also provide flowcharts for the most commonly used menus and
procedures.
1.7
Using this manual
If the Marine Bunker Transfer Package is installed, use the manual entitled Series 3000 Transmitters:
Marine Bunker Transfer Package Supplement as your first guide to installation, configuration, and
use.
Marine Bunker Transfer Package Supplement as your first guide to installation, configuration, and
use.
If the Marine Bunker Transfer Package is not installed, follow the general task sequence described
below to install, configure, and use the Series 3000 device.
below to install, configure, and use the Series 3000 device.
1. Install the Series 3000 device (Chapter 2).
2. Set up digital communications (Chapter 3).
3. Learn to use the display and menu system (Chapter 4).
Failure to perform configuration tasks in the proper sequence could result in an incomplete
configuration. Perform the configuration procedures in this order:
configuration. Perform the configuration procedures in this order:
a.
Configure security and language (Chapter 5).
b.
Configure system data (Chapter 6).
c.
Configure inputs (Chapter 7).
d. Configure petroleum measurement parameters, if the petroleum measurement application
(API feature) is installed (see Chapter 9), or enhanced density parameters, if the enhanced
density application is installed (see the enhanced density manual, available on the Micro
Motion web site).
density application is installed (see the enhanced density manual, available on the Micro
Motion web site).
Note: The Series 3000 device does not support simultaneous use of the petroleum measurement
application and the enhanced density application. If you ordered either of these applications, it
should already be installed on your Series 3000 device, but not configured or enabled.
application and the enhanced density application. If you ordered either of these applications, it
should already be installed on your Series 3000 device, but not configured or enabled.
e.
Configure discrete events (Chapter 10).
f.
Configure the discrete batch application, if it is present (Chapter 11).
g. Configure outputs (Chapter 8).
h. Configure the process monitor (Chapter 12).
i.
Configure digital communications (Chapter 13).
j.
Configure custody transfer (Chapter 14).
k. Configure ticket formatting and ticket printing (Chapter 15).