Emerson Series 3000 MVD User Manual

144

Micro Motion

Series 3000 MVD Transmitters and Controllers

Operation Mode

17.4

Process monitor operation mode

The process monitor, shown in Figure 17-1, is the default operation mode unless the discrete batch
application is present.

•

To scroll through the process monitor, press the left or right cursor control button. The number
beside each arrow on the top line indicates the screen that will be displayed if the left or right
cursor control button is pressed. If no display variables are configured for a particular screen,
that screen is skipped.

•

If a total appears on the screen, you can press

RESET

to reset it to 0. Pressing

RESET

will

reset only the totals on the screen that is displayed.

•

Press

PRINT

to print a ticket that includes values of process variables on the screen that is

displayed.

You can configure the process variables that will be displayed on each of the five screens of the
process monitor. To configure the process monitor, see Chapter 12.

If the discrete batch application is installed, you can monitor process variables by using the Process
Monitor option from the View menu (see Section 17.5).

Figure 17-1

Series 3000 display in process monitor mode

CAUTION

Failure to perform a sensor zero calibration at initial startup could cause the
flowmeter to produce inaccurate signals.

To avoid inaccurate measurements, perform a sensor zero before putting the
flowmeter into operation.

Cursor control
buttons

Security button

Backlit

display

Function buttons

←

DEVICE 1

→2

Mass Flow Rate

2.33

g/s

Mass Total

485.88

RESET

EXIT

VIEW or EXIT
button