Emerson Series 3000 MVD User Manual
Configuration and Use Manual
269
Installing Relays
Rela
y In
stal
latio
n
Series
3
000
Men
u
s
Defaults
Spec
ifications – Model
3
100
D.7
Installing user-supplied relays
Follow these steps to install user-supplied relays.
Step 1
Connect discrete output terminals to relays
Follow the steps below to connect the transmitter/controller’s discrete output wiring terminals to one,
two, or three relays.
two, or three relays.
1. Use the following wire sizes:
•
Model 3300 or Model 3500: 24 to 16 AWG (0,25 to 1,5 mm
2
)
•
Model 3350 or Model 3700: 22 to 16 AWG (0,35 to 1,5 mm
2
)
2. Connect the wires between the transmitter/controller and the relay as shown in Table D-2 and
in the following diagrams:
•
Model 3300 or Model 3500 with screw-type or solder-tail connectors: see Figure D-8
•
Model 3300 or Model 3500 with I/O cables: see Figure D-9
•
Model 3350 or Model 3700: see Figure D-10
WARNING
Shock Hazard.
Improper installation of wiring, or installation with power supply on, can cause
electric shock or property damage.
electric shock or property damage.
For personal and system safety:
•
Shut off power before installing wiring.
•
Make sure the installation meets or exceeds local code requirements.
•
Install relays and wiring in accordance with the illustrations in these instructions.
•
Install relays and wiring where ambient temperature remains between –4 and
+140 °F (–20 and +60 °C).
+140 °F (–20 and +60 °C).
Table D-2
Transmitter/controller terminals for user-supplied relays
Transmitter/controller terminals
Terminal function
Model 3300 or Model 3500
Model 3350 or Model 3700
I/O cables or I/O
terminal block
terminal block
Screw-type or
solder-tail
terminals
solder-tail
terminals
Gray terminal block
19
a 14
20
Return
18
c 14
18
DO1
20
c 16
17
DO2
22
c 18
16
DO3