Dantax LR-8500 User Manual
- 8 -
Connections
ZONE II SPEAKER OUTPUTS
Surround Back/ZONE II Speaker Outputs:
These speaker terminals are normally used to
power the surround back left/surround back right
speakers in a 7.1-channel system. However, they
may also be used to power the speakers in a sec-
ond zone. which will receive the output selected
for a ZONE II SPEAKER system. To change the
output fed to these terminals from the default of
the Surround Back speakers to the ZONE II
SPEAKER Output, you must change a setting in
the ZONE II SETUP of the OSD system. See page
30 for more information on configuring this speak-
er output. For ZONE II SPEAKER use, connect the
brown and black SBL terminals to the red and
black connections on the left remote zone speak-
er and connect the tan and black SBR terminals to
the red and black terminals on the right remote
zone speaker.
These speaker terminals are normally used to
power the surround back left/surround back right
speakers in a 7.1-channel system. However, they
may also be used to power the speakers in a sec-
ond zone. which will receive the output selected
for a ZONE II SPEAKER system. To change the
output fed to these terminals from the default of
the Surround Back speakers to the ZONE II
SPEAKER Output, you must change a setting in
the ZONE II SETUP of the OSD system. See page
30 for more information on configuring this speak-
er output. For ZONE II SPEAKER use, connect the
brown and black SBL terminals to the red and
black connections on the left remote zone speak-
er and connect the tan and black SBR terminals to
the red and black terminals on the right remote
zone speaker.
ZONE II AUDIO OUTPUT
Connect these jacks to the optional external audio
power amplifier and video distribution system that
delivers the source selected for ZONE II distribu-
tion.
power amplifier and video distribution system that
delivers the source selected for ZONE II distribu-
tion.
PRE OUT ( SUB WOOFER ) jack
Use this jack to connect a powered sub-woofer or
passive sub-woofer with a power amplifier
(OPTIONAL) .
passive sub-woofer with a power amplifier
(OPTIONAL) .
Power cord (AC INPUT)
Be sure to connect the power cord to an AC outlet
which supplies the correct voltage.
which supplies the correct voltage.
Hold the power plug when plugging or unplugging
the power cord.
the power cord.
AC OUTLET (SWITCHED)
This outlet is only active when the receiver is
turned on.
turned on.
Caution:
Make sure that the total power consumption of all
equipment connected to the outlets on the receiv-
er does not exceed 100 watts.
equipment connected to the outlets on the receiv-
er does not exceed 100 watts.
RS-232C
The RS-232C port may also be used in the future to
update the operating software of the LR-8500 so
that it will be able to support new digital audio for-
mats and the like as they are introduced.
update the operating software of the LR-8500 so
that it will be able to support new digital audio for-
mats and the like as they are introduced.
RC-232C
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
RIGHT
FRONT
SURROUND
BACK
LEFT
RIGHT
RIGHT
RIGHT
SURROUND
CENTER
(OPTIONAL)
POWERED
SUBWOOFER
AC OUTLET
AC INPUT
ZONE II AUDIO
OUTPUT
OUTPUT
SPEAKERS, PRE OUT, AC OUTLET, RS-232C