Philips AZ5160 User Manual

10

AZ 5160/98  

page

10

1. Check if the mains voltage as shown on the type plate (on

the bottom of the set) corresponds to your local mains
voltage. If it does not, consult your dealer or service
organization. 

2. Connect the mains lead to the AC MAINS 

socket and the

wall socket.
™ The set is now ready for use.

3. To switch off the mains supply completely, pull the mains plug out of the wall socket.

™ Disconnect the mains lead when you change over to battery supply, or to protect the set

during heavy thunderstorms.

1. To switch on the set, adjust the source selector.
2. Adjust the sound using the VOLUME and DBB controls.
3. To switch off the set, adjust the source selector to the

TAPE/OFF position, with the cassette keys released.

1. Set the source selector to TUNER.
2. Adjust BAND to FM or MW as your desired band.
3. Adjust the sound using the VOLUME controls and the DBB

switch.

4. Tune to a radio station using the TUNING knob.

– For FM, pull out the telescopic aerial. To improve FM-reception,

incline and turn the aerial. Reduce its length if the FM-signal is
too strong (very close to a transmitter).

– For MW, the set is provided with a built-in aerial, so the 

telescopic aerial is not needed. Direct the aerial by turning 
the whole set.

5. To switch off, set the source selector to the TAPE/OFF 

position (with the cassette keys released).

Å

90

33

22

2

Å

90

33

22

2

Å

90

33

22

2