Bradley Smoker FL-1L User Manual

Page of 8
Installation 
FL-1H, FL-1L
Bradley Corporation • 215-1511 Rev. D; EN  07-808 
5/30/07 
3
Cleaning and Maintenance for Terreon
®
Material Description:  Terreon
®
 is an NAHB Certifi ed densifi ed solid surface material composed of polyester resin and is 
resistant to chemicals, stains, burns and impact. Surface damage can be easily repaired with everyday cleansers or fi ne grit 
abrasives.
Routine Cleaning:  Clean daily or as often as conditions require using a standard commercial or household cleaner such as 
Formula 409
®
 or Windex
®
.
Stubborn Stains:  Remove tough stains with Ajax
®
, Comet
®
, or Soft-Scrub
®
 and a green Scotch-Brite
®
 pad or lightly sand in 
a circular motion with 240 grit wet/dry sandpaper. The fi nish can be renewed with a maroon Scotch-Brite
®
 pad.
Special Situations for Material
Scratches:  Remove scratches with a green Scotch-Brite
®
 pad. The fi nish can then be renewed with a maroon Scotch-Brite
®
 
pad, followed by a white Scotch-Brite
®
 pad or 30-micron sandpaper.
Hard Water Deposits:  Remove hard water deposits with a mild solution of vinegar and water. Always rinse the unit 
thoroughly after cleaning.
Restoring the surface:  Use Hope’s
®
 Solid Surface cleaner and polish to refresh and protect the Terreon
®
 Solid Surface 
material. Bradley recommends additional care and maintenance for the darker colored Terreon
®
, for complete instructions on 
this additional maintenance refer to Bradley technical document #1505.
Do not use strong acid or alkaline chemicals and cleansers to clean Terreon
®
. If these chemicals come in 
contact with the surface, wipe them off immediately and rinse with soapy water. Avoid contact with harsh 
chemicals such as paint remover, bleach, acetone, etc.  Avoid contact with hot pans and objects.
Repair Kits:  Terreon
®
 repair kits are available. Contact your Bradley representative or distributor for part numbers and pricing 
Repair kits are made to order and have a shelf life of 30 days.
Terreon
®
 is a unique, cast solid surface material. Aggregate fl ow and distribution as well as shades of color can vary from 
product to product creating natural characteristics.
Brand Names:  Use of brand names is intended only to indicate a type of cleaner. This does not constitute an endorsement, 
nor does the omission of any brand name cleaner imply inadequacy. Many products named are regional in distribution, and 
can be found in local supermarkets, department and hardware stores, or through your cleaning service. It is emphasized that 
all products should be used in strict accordance with package instructions.
Dimensions - Front and Top Views
7-3/4"
(197mm)
22"
(559mm)
30"
(762mm)
37-3/4"
(959mm)
36"
(914mm)
30"
(762mm)
34"
(864mm)
12-1/4"
(311mm)
30"
(762mm)
37-3/4"
(959mm)
32"
(813mm)
30" ADA
(762mm)
34" ADA
(864mm)
12-1/4" ADA
(311mm)
ADA
COMPLIANT
FL-1H shown
FL-1L is similar
FL-1H
FL-1L