Hearth & Home Technologies 21M-ACC User Manual

Page  28

7039-131F

September 1, 2008

R

1.  Ensure that the fire is out and the appliance is cool to 

the touch.

2.  Protect a table or counter top with padding or towels. 

Protect your hands and wear gloves to prevent injury.

.  Remove the door with the broken glass by lifting the 

door up and off of the hinges.

4.  Lay door face down on a table or counter making sure 

the handle hangs over the edge so the door lays flat, on 

a soft surface. 

5.  Remove the screws from each glass retainer and remove 

the glass. (If screws are difficult to remove, soak with 

penetrating oil first).

6.  Center  the  glass  with  edges  evenly  overlapping  the 

opening in the door, (i.e. same space top and bottom, 

left and right sides).

7.  Replace the glass retainers.  Be careful not to cross 

thread the screws.

8.  Tighten  each  retainer  just  a  few  turns  until  each  is 

secured.  Check again for centering of glass in door 

frame.  Continue to tighten each retainer alternately, a 

few turns at a time, until the glass is secure.  DO NOT 

OVERTIGHTEN.

9.  Replace the door on the appliance.
Quadra-Fire stoves are equipped with ceramic super heat-

resistant  glass,  which  can  only  be  broken  by  impact  or 

misuse.  Do not slam stove door or impact the glass.  When 

closing door, make sure that logs do not protrude against the 

glass. Inspect glass regularly.  If you find a crack or break, 

immediately put the fire out and return the door to your dealer 

for replacement of glass before further use.

Handle glass assembly with care.
When cleaning glass:

•  Avoid striking, scratching or 

slamming glass.

•  Do NOT clean glass when hot.

•  Do NOT use abrasive cleaners.

•  Use a hard water deposit glass cleaner on white film.

•  Use commerical oven cleaner on heavier deposits.

•  Remove all residue of oven cleaner or will permanently 

stain glass on next firing.

• 

Refer to maintenance instructions.

Glass 

Assembly

Handle glass with care.
•  Inspect the gasket to ensure it is 

undamaged.

•  Do NOT strike, slam or scratch glass.
•  Do NOT operate appliance with glass 

& door assembly removed. 

Glass 

Assembly

•  Do NOT operate with glass cracked, broken or scratched.

•  Use only glass specified in manual.
•  DO NOT REPLACE with any other material.
Glass breakage will occur.