Hearth & Home Technologies CASTILE-PMH1 User Manual

Page of 48
Page  2
250-6422E
September 1,  2008
R
Castile Pellet Stove 
Hearth & Home Technologies welcomes you to our tradi-
tion of excellence!  In choosing a Quadra-Fire appliance, 
you have our assurance of commitment to quality, durabil-
ity, and performance.
This commitment begins with our research of the market, 
including ‘Voice of the Customer’ contacts, ensuring we 
make products that will satisfy your needs. Our Research 
and Development facility then employs the world’s most 
advanced technology to achieve the optimum operation of 
our stoves, inserts and fireplaces.  And yet we are old-fash-
ioned when it comes to craftsmanship.  Each unit is meticu-
lously fabricated and surfaces are hand-finished for lasting 
beauty and enjoyment.  Our pledge to quality is completed 
as each model undergoes a quality control inspection.    
We wish you and your family many years of enjoyment in 
the warmth and comfort of your hearth appliance.  Thank 
you for choosing Quadra-Fire.
SAMPLE OF CLEARANCE TO COMBUSTIBLES LABEL
LOCATION:  Back side of left side panel.
Listed Solid Fuel Room Heater/Pellet Type Insert.  Also suitable for Mobile Home Installation.  This appliance has 
been tested and listed for use in Manufactured Homes in accordance with OAR 814-23-9000 through 814-23-909. 
PREVENT HOUSE FIRES 
Install and use only in accordance with manufacturer's installation and operating instructions.  Contact local 
building or fire officials about restrictions and inspection in our area. 
WARNING - FOR MOBILE HOMES:
  Do not install appliance in a sleeping room.  An outside combustion air 
inlet must be provided.  The structural integrity of the mobile home floor, ceiling and walls must be maintained. 
Refer to manufacturer's instructions and local codes for precautions required for passing chimney through a 
combustible wall or ceiling.  Inspect and clean vent system frequently in accordance with manufacturer's 
instructions.
DO NOT CONNECT THIS UNIT TO A CHIMNEY SERVING ANOTHER APPLIANCE.
Use a 3" or 4" diameter type "L" or "PL" venting system. 
Tested to: ASTM E1509-95, ULC S627-00, ULC/ORD-C-1482-M1990 Room Heating Pellet Burning Type, 
(UM) 84-HUD FOR USE ONLY WITH PELLETIZED WOOD OR SHELLED FIELD CORN FUEL.
Input Rating:  30,000 Btu's/hr
Electrical Rating: 115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 AMPS.
Route power cord away from unit. Do not route cord under or in front of appliance.
DANGER:  Risk of electrical shock
.  Disconnect power supply before servicing.  Replace glass only with 5mm 
ceramic available from your dealer.  To start, set thermostat above room temperature, the stove will light 
automatically.  To shutdown, set thermostat to below room temperature.  For further instruction refer to owner's 
manual.Keep viewing and ash removal doors tightly closed during operation.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS / 
ESPACES LIBRES MINIMUM DES MATÉRIAUX COMBUSTIBLES:  
U.S. ENVIRONMENTAL PROTECTION AGENCY  This model is exempt from EPA certification under 40 CFR 60.531 by definition [Wood Heater (A) "Air-to-Fuel Ratio"].
250-6411 
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER L'ÉTIQUETTE 
Made in U.S.A./Fait Aux États-Unis 
PRÉVENTION DES FEUX DE MAISON 
I
nstallez et utilisez en accord avec les instructions d'installation et d'opération du fabricant. Contactez le bureau de la 
construction ou le bureau des incendies au sujet des restrictions et des inspections d'installation dans votre voisinage. Ne 
pas obstruez l'espace en dessous de l'appareil. 
AVIS - Pour Les Maisons Mobiles:
  Ne pas installer dans une chambre à coucher. Un tuyau extérieur de combustion d'air 
doit être installé et ne doit pas être obstrué lorsque l'appareil est en usage. La structure intégrale du plancher, du plafond et 
des murs de la maison mobile doit être maintenue intacte. 
Référez vous aux instructions du fabricant et des codes locaux pour les précautions requises pour passer une cheminée à 
travers un mur ou un plafond combustibles, et les compensations maximums. 
Inspectez et nettoyez la cheminée fréquemment. Ne pas connecter cet appareil à une cheminée servant un autre appareil. 
Utilisez systèm de ventilation "L" ou "P" diamètre 76mm ou 102mm. 
Testé à: ASTM #1509-95, ULC S627-00 ULC/ORD-C 1482-M1990 Room Heating.  Pellet Burning Type, (UM) 84-HUD 
POUR USAGE AVEC LES BOULETTES DE BOIS OU DE COMBUSTIBLE DE MAIS ÉCOSSÉ DES CHAMPS.
Puissance de Rendement: 30,000 Btu's/hr
Puissance Électrique: 115 VAC, 60 Hz, Début 4.1 Amps, Courir 1.1 Amps, 
Éloignez le fil électrique de l'appareil. Ne pas faire passer le fil électrique au dessus ou en dessous de l'appareil.
DANGER: Il y a risque de décharge électrique. 
 Déconnectez le fil électrique de la prise de contact avant le service.
Remplacez la vitre seulement avec une vitre céramique de 5 mm disponible chez votre fournisseur.
Pour allumer, monter la température du thermostat au dessus de la température de la pièce, le poêle s'allumera 
automatiquement.  Pour éteindre, descendre la température du thermostat en dessous de la température de la pièce.  Pour des 
instructions supplémentaires, référez vous au manuel du propriétaire.  Gardez la porte d'ouverture et la porte des cendres 
fermées hermétiquement durant l'opération.
Appareil de chauffage inséré de combustible solide/de type de boulettes.  Accepté dans l'installation dans les maisons mobiles.  Cet
appareil a été testé et enregistré pour l'usage dans les Maisons Mobiles en accord avec OAR 814-23-9000 jusqu'à 814-23-909.
1445 Highway North 
Colville, WA  99114 
Mfg by:Fabriqué par
:
R
Report / Rapport
061-S-33-2
Castile Pellet Stove 
SERIAL NO. / NUMÉRO DU 
Back Wall to stove / Mur Arrière du poêle 
2"/51mm
Side Wall to Cast Top / Mur De Côté du haut 
 
6"/152mm
CORNER INSTALLATION / NSTALLATION DU COIN :
Side Wall / Mur De Côté 
2"/51mm
VERTICAL 3" - 6" ADAPTER KIT (PART 812-3570) INSTALLATION: 
UN ASSEMBLAGE POUR ADAPTEUR 3" - 6" (PIÈCE 812-3570) POUR INSTALLATION VERTICALE:
D
Back Wall to Flue Pipe / Mur Arrière tuyau rigide 
 
3"/76
mm
Side Wall to Cast Top / Mur De Côté du haut 
 
6"/152mm
CORNER INSTALLATION WITH VERTICAL ADAPTER KIT: 
INSTALLATION DU COIN AVEC UN ASSEMBLAGE D'ADAPTEUR VERTICAL:
Side Wall / Mur De Côté 
2"/51mm
ALCOVE INSTALLATION /
INSTALLATION DE L' ALCÔVE:
Min. Alcove Height: / Une hauteur minimum de l'alcôve 
 
43"/1092mm
Min. Alcove Side Wall: / Une hauteur minimum mur de côté de l'alcôve 
6"/152mm
Max. Alcove Depth: / La profondeur maximum de l'alcôve 
 
36"/914mm
Floor protector must be noncombustible material, extending beneath heater and to the 
front/sides/rear as indicated.  Measure front distance (I) from the surface of the glass 
door. 
G =  2"/51mm 
H* = 2"/51mm 
 I  =  6"/152mm 
FLOOR PROTECTION / PROTECTION DU SOL 
Note 1:
 In residential installations, when using Parts 811-0890, (3" - 3" Top Vent Adapter) and 812-3570 (3" - 6" Offset 
Adapter), 24 gauge 6" single wall flue connector may be used. 
Note 1:
Dans les installations résidentielles, lorsque les pièces 811-0890, (dessus de l'adapteur de ventilation 3" - 3") et
812-3570 (le ressaut de l'adapteur 3" - 6"), un tuyau connecteur de 6" pour mur simple de calibre 24 peut être utilisé. 
Note 2:
 In manufactured home installation, when using Part 811-0890, (3" - 3" Top Vent Adapter) and 812-3570 (3' - 6" 
Offset Adapter), use listed double wall flue connector.  An Outside Air Kit (Part 811-0872), must be used with manufactured 
home installation. 
Note 2:
Pour l'installation dans les maisons préfabriquées, lorsque les pièces 811-0860, (dessus de l'adapteur de
ventilation 3" - 3") et 812-3570 (le ressaut de l'adapteur 3" - 6"), utilisez un tuyau connecteur enregistré pour mur double. 
Un assemblage d'air extérieur (pièce 811-0872), doit être utilisé pour l'installation dans les maisons préfabriquées. 
*Non-combustible floor protection must extend beneath the flue pipe when installed with 
horizontal venting or under the Top Vent Adapter with vertical installation. 
 
RECOMMENDED IN USA;  REQUIRED IN CANADA 
Le poêle doit être placé sur une assise non combustible s’étendant tout autour de lui, comme les 
schémas l’indiquent. Mesurez la distance du devant (I) de la surface de la porte vitrée.
*Un protecteur incombustible de plancher doit s'étendre sous le conduit de cheminée 
pour une installation de ventilation horizontale ou sous un adapteur de ventilation de 
dessus pour une installation verticale. ÉTATS-UNIS - RECOMMANDÉ;  CANADA - 
REQUIRENT
C
C
D
E
"E" is to Cast Top 
("E" du haut) 
B
"B" is to Cast Top 
("B" du haut) 
F
F
H*
G
G
I
    2008   2009  2010   Jan.    Feb.    Mar.   Apr.    May   June    July   Aug.   Sept.    Oct.  Nov.    Dec.
SAMPLE 
O-T 
L
Tested and 
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C
US
Mfg. Date
Serial Number
Model Name
Test Lab & 
Report No.