Kenwood KAC-X810D User Manual

1. Install the installation fittings in the unit.
2. Attach the unit.
3. Install the terminal cover.

• Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location that gets wet, In a
dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that
gets hit by hot air)

• Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be

damaged.

• Install this unit in a location which allows heat to easily dissipate.

Once installed, do not place any object on top of the unit.

• The surface temperature of the amplifier will become hot during use. Install the amplifier in a

place where people, resins, and other substances that are sensitive to heat will not come into
contact with it.

• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check

that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or
wiring harness, and be careful not to cause scratches or other damage.

• Do not install near the dashboard, rear tray, or air bag safety parts.
• The installation to the vehicle should securely fasten the unit to a place in which it will not

obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may
cause injury or an accident.

• After installing the unit, check to make sure that electrical equipment such as the brake lamps,

turn signal lamps and windshield wipers operate normally.

2CAUTION

Installation board, etc.
(thickness : 15 mm or more)

Self-tapping screw
(ø5 

× 18 mm)

Terminal
caver

Mounting
Hardware

Hexagon socket
head cap screw 
(M3 

× 8 mm)

Self-tapping screws 
(ø3 

× 8 mm)

Hexagon
Wrench