Lyngdorf Audio MkIV User Manual
- 8 -
Quick set-up
A. Connect your speaker cables to the terminals on the back panel. The speaker
impedance should be 4-16 Ohms. If the speakers can be bi-wired, use both sets of
terminals. Make sure that the red (+) terminal gets connected with the corresponding
positive (+) terminal on your speaker. European versions of the Millennium will not accept
banana plugs. Do not attempt to remove the plastic safety plugs, use spades or simply
bare wires.
B. Connect your CD/DVD/MD/DAT player to one of the digital inputs or an analog source
to the A.l.M. Turn on the power to your source.
C. Turn on the Millennium with the power button (1).
D. Press the analog or digital (2/4) input selector once. The Millennium will now boot up
and you must select the input where you connected the source. If the Equibit logo is
flashing, press the input selectors 2 or 4 to find the right source. When the Millennium
detects a signal, the logo will stop flashing.
E. Adjust the volume with the wheel (3) to a moderate level.
F. Activate your digital or analog source and adjust the volume.
If you experience any problems during this procedure, please refer to the following
pages for a more detailed explanation of the set-up.
impedance should be 4-16 Ohms. If the speakers can be bi-wired, use both sets of
terminals. Make sure that the red (+) terminal gets connected with the corresponding
positive (+) terminal on your speaker. European versions of the Millennium will not accept
banana plugs. Do not attempt to remove the plastic safety plugs, use spades or simply
bare wires.
B. Connect your CD/DVD/MD/DAT player to one of the digital inputs or an analog source
to the A.l.M. Turn on the power to your source.
C. Turn on the Millennium with the power button (1).
D. Press the analog or digital (2/4) input selector once. The Millennium will now boot up
and you must select the input where you connected the source. If the Equibit logo is
flashing, press the input selectors 2 or 4 to find the right source. When the Millennium
detects a signal, the logo will stop flashing.
E. Adjust the volume with the wheel (3) to a moderate level.
F. Activate your digital or analog source and adjust the volume.
If you experience any problems during this procedure, please refer to the following
pages for a more detailed explanation of the set-up.