Vocopro KC-300Pro User Manual
Getting Connected
14
VCR Player
Connecting a Video Cable to the TV
The KC-300Pro has two VIDEO OUTPUT jacks.
The KC-300Pro has two VIDEO OUTPUT jacks.
(a) Connect an RCA video cable from the desired VIDEO OUTPUT jack on the KC-300Pro to the
VIDEO INPUT jack on the TV. Some TV’s will require that you manually switch the TV to the
VIDEO INPUT mode. Other TV’s will automatically switch to the video mode when they detect a
video signal at the video input jack. On most TV’s the jack is labeled AUX or VIDEO.
VIDEO INPUT jack on the TV. Some TV’s will require that you manually switch the TV to the
VIDEO INPUT mode. Other TV’s will automatically switch to the video mode when they detect a
video signal at the video input jack. On most TV’s the jack is labeled AUX or VIDEO.
(b) If the TV does not have a VIDEO INPUT jack you may connect that end of the cable to the
VIDEO INPUT of a VCR and connect the RF OUTPUT of the VCR to the TV ANTENNA INPUT jack
on your TV.
VIDEO INPUT of a VCR and connect the RF OUTPUT of the VCR to the TV ANTENNA INPUT jack
on your TV.
(c) If there is no VCR present, you will need to
use an RF Modulator. To obtain an RF Modulator,
check with your VocoPro dealer. An RF Modulator
can also be purchased from Radio Shack™.
use an RF Modulator. To obtain an RF Modulator,
check with your VocoPro dealer. An RF Modulator
can also be purchased from Radio Shack™.
Powering Up
(a) Plug the power cord of the KC-300Pro to a 120-Volt AC wall outlet. To operate the
KC-300Pro from a 220V AC power source, it will be necessary to switch the voltage selector to
220V. This can be done by locating the voltage selector on the rear panel of the KC-300Pro and
switching it to the 220V setting.
KC-300Pro from a 220V AC power source, it will be necessary to switch the voltage selector to
220V. This can be done by locating the voltage selector on the rear panel of the KC-300Pro and
switching it to the 220V setting.
(b) Turn on your input source(s), amplifier/receiver and TV. Do not turn on the KC-300Pro.
(c) Be sure your TV is set to receive video input from the VIDEO INPUT jack. (Some TV’s use a
VIDEO INPUT, AUX or CHANNEL 0 as a “dedicated” video channel). Check you TV’s instruction
manual to see how it selects its video channel(s).
(d) Hit the POWER button on the KC-300Pro.
Your Installation Is Complete!
Note: Plugging the KC-300Pro into a 220V
power source can severely damage
the unit and will void the warranty.
power source can severely damage
the unit and will void the warranty.
TV
TV
IN
KC-300Pro
RCA
Video cable
Video cable
yellow
RCA
Video cable
Video cable
yellow
IN
KC-300Pro
RF Modulator
INPUT AC VOLTAGE:115 V/230 V
POWER CONSUMPTION: 18W
AC ~
115
AUX
HI
LO
BBE ON
MULTI - AUDIO
UP
RESET
DOWN
MIN MAX
MUSIC VOL
INPUT SELECTOR
SONIC ENHANCER
VOCAL CANCEL
DSP KEY CONTROLLER
MULTI - DISPLAY
RECEIVER
POWER
DSP KEY CONTROLLER
SONIC ENHANCER
KC-300Pro
AV2
AV1
AUX
HI
LO
BBE ON
MULTI - AUDIO
UP
RESET
DOWN
MIN MAX
MUSIC VOL
INPUT SELECTOR
SONIC ENHANCER
VOCAL CANCEL
DSP KEY CONTROLLER
MULTI - DISPLAY
RECEIVER
POWER
DSP KEY CONTROLLER
SONIC ENHANCER
KC-300Pro
AV2
AV1