Lucent Technologies 585-210-940 User Manual

2

It is likely that your 

Enterprise 3500 system is currently using controller 1 

(c1) for the internal CD-ROM drive. This step associates the CD-ROM 
drive with controller 2 (c 2) so controller 1 will be free for the new disk 
drives. In this step you also install some additional hardware for 
controlling the new disks, and install the new disks themselves. You 
should be logged in as 

root before beginning this step.

1. Enter the following command:

______________________________________________________

#

ls

-l

/dev/dsk/c1t6d0s0

______________________________________________________

The system should respond with a line similar to the following:
______________________________________________________

lrwxrwxrwx

1

roor

roor

50 Nov 16 08:58 

/dev/dsk/c1t6d0s0 -> ../../devices/sbus@3,0 

/SUNW,fas@3,8800000/sd@6,0:a

______________________________________________________

Notice that c1t6d0s0 is pointing to sd@6,0:a. That indicates that 
controller 1 is being used by the CD-ROM drive. Remove that 
association by entering the following commands:
______________________________________________________

#

rm

/dev/dsk/c1*

#

rm

/dev/rdsk/c1*

#

touch

/reconfigure

#

/usr/sbin/shutdown

-y

-g0

-i0

______________________________________________________

2. Install new hardware components as follows:

●

Install a GigaByte Interface Converter (GBIC) into slot UA on 
the Interface board.

●

Install another GBIC into port 1 on the SBus I/O board.

●

Install a fiber cable between the two newly installed GBICs.

The illustration below shows where the GBICs are installed. For 
more detailed information, see 

CentreVu CMS Sun Enterprise 3500 

System (connectivity diagram) (585-215-877), which was packed 
with your system.