SpeakerCraft Starlet 6 User Manual

Page 2

Starlet Owner’s Manual

GETTING STARTED

Your Starlet 4, 6 or 9 speakers are individually packed with the following:

• Back Box/Driver Assembly

• Bezel/Flange Assembly

• Cardboard Cut-Out Template and Paint Mask

• Accessory Pack (See Diagram 1)

• Outer Bracket

• Inner Bracket

• Foam Support Block

• Screws: Two M4 x 20mm for Outer/Inner Bracket

Two Hex Head M4 x 45mm Screws per Driver

(8 for Starlet 4, 12 for Starlet 6 and 18 for Starlet 9)

• 3mm Hex Head M4 Driver Bit (for electric screwdriver)

Also available separately for the Starlets 6 and 9:

• SCT-1.0 Starlet Calibration Tools

• ASM89000: Complete Kit with Test CD and Analog Voltmeter with Leads

• ASM89001: Test CD Only

For installation of your Starlets, you will need the following:

• Stud Finding Tool

• Masking tape or tacks (for template)

• Drywall Saw

• Level

• Electric Screwdriver

• Wire Strippers

• Hand Screwdriver with #2 Phillips Head

• Utility Knife

• Pencil (for marking wall)

• Tape Measure

Amplifier Requirements:

• Starlet 4: Minimum 75 watts per channel stereo amplifier with low impedance capability (i.e. SpeakerCraft BB275)

• Starlets 6 and 9: Two (2) minimum 75 watts per channel stereo amplifiers with low impedance capability and individual

level controls on each channel

• The SpeakerCraft BB275 is a good starting point for all 3 models of the Starlet

Diagram 1:

Accessory Pack