Velodyne Acoustics SMS -1 User Manual

.

(10)

RS-232 OUT – Use this port to communicate with a second “daisy-chained” Digital
Drive SMS-1.

(11)

RS-232 IN – Use this port to communicate with your computer (for software
updates), a touch panel remote control, or another upstream Digital Drive SMS-1.
See Appendix A for an explanation of the use of the serial port, available commands,
and their formats.

(12)

EQ Video Output – Used to display the video generated by the SMS-1.  S-Video or
composite connections are available.  A composite video cable is included.  NOTE:
Only connect to a single video output at a time.

(13)

LFE OUTPUT – These connectors send the conditioned subwoofer audio signal to up
to three subwoofers.

(14)

EQ OUTPUT LEFT/RIGHT – Connect the audio cable from your accessory kit to these
jacks: white plug to LEFT, and red plug to RIGHT.  

(15)

THRU – These RCA connectors are for sharing the same signal that goes into your
SMS-1 with a second “daisy-chained” SMS-1 or other device. Unaltered line-level
signal comes out of the THRU jack.

(16)

OUTPUT – These RCA connectors incorporate the use of an 80Hz 6 dB/octave slope
high pass crossover.

(17)

INPUT LFE – These RCA input jacks are for line-level connection.

(18)

12V TRIGGER/SPEAKER LEVEL INPUT RIGHT/LEFT – If the 12 volt trigger mode is
active, 12 volts is required across these pins for power to be activated.  The speaker-
level connector allows for connection with exposed speaker wire.

(19)

12V DC POWER SUPPLY INPUT - Connect the power supply to this jack.