Philips MCM275 User Manual
16
English
Preparation
Setting the clock
After connecting MCM275 to the power supply,
set the clock first.
set the clock first.
1
Press and hold
STANDBY-ON to switch the
set to Standby mode
➜
The display shows the set time
➜
-- --:-- -- flashes by default if you have not set
the clock
2
In the standby mode, press and hold
DISPLAY/
CLOCK on the remote control
➜
SET CLOCK scrolls on the display
➜
24 HR or 12 HR appears for the initial
clock setting. To select 24-hour clock or
12-hour clock,
12-hour clock,
●
On the remote control, press
VOLUME +/-
once or more (or turn
VOLUME on the
set)
●
On the remote control, press
DISPLAY/
CLOCK to confirm
➜
The hours digits start flashing
3
Hold down or press
VOLUME +/- repeatedly
to set the hours (or turn
VOLUME on the
set)
4
Press
DISPLAY/CLOCK to confirm
➜
The minutes digits start flashing
5
Hold down or press
VOLUME +/- repeatedly
to set the minutes (or turn
VOLUME on the
set)
6
Press
DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press
STOP
STOP
9
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
no button is pressed within 90 seconds.
Using the remote control
IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
protective plastic tab
before using the
remote control.
– Always point the
remote control directly
towards IR area.
remote control directly
towards IR area.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example
ÉÅ, í , ë).
To replace the remote controls’
battery
battery
CR 20
25
LIT
HIUM
2
➠
3
1
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
1
Press and hold 1 as indicated.
2
Simultaneously, pull the battery tray at 4.
3
Remove the old batter y and put a new CR2025
battery in place.
battery in place.
4
Put back the battery tray.
USB
/
P001-P031_MCM275_37_Eng
12/20/2005, 09:40
16