Cardo Q2 User Manual

sure to clean the selected area prior to the gluing process).

4. Use the pre-moistened Towelette to clean the helmet area where 

you want to install the Glue Plate. Allow to dry thoroughly.

5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press firmly 15 

seconds on all 3 parts of the Glue Plate.

7. The adhesive pad bonds to full strength over the next 24 hours. 

Therefore it is recommended to not use the headset during this 24 

hour period.

8. Fasten the Clamp to the Glue Plate using the Allen screws that were 

previously removed.

microphone, please proceed as follows: 

If you are using the corded microphone version, you must first make 

sure your helmet clamp is attached to your 

helmet as described in previous section 

(ATTACHING THE CLAMP ON THE HELMET). 

Clean the exact spot on the internal padding of 

the helmet, opposite your mouth, where the 

microphone will be placed and proceed as 

follows.
a. Peel the foil cover from the adhesive Velcro 

pad and place the Velcro pad on the chosen 

location opposite your mouth.
b. Attach the microphone to the Velcro, as shown 

in photo.

c. When done, tighten the screws of the clamp

Attach the speakers to the Velcro inside 

your helmet opposite your ears (short 

speaker cord for the left ear [A] and the 

long speaker cord [B] for the right ear). You 

may want to use the supplied Velcro pad.

Using two speakers inside the helmet 

may be prohibited in certain 

jurisdictions. If this is the case, 

you should tuck away the long 

corded speaker underneath the 

helmet padding as follows: 
Lead the speaker cord [B] along-

side the rim of the padding to 

the right side and then back 

to the left side, near speaker 

[A]. Then place the speaker [B] 

underneath the padding. 

Slide the headset downwards along the 

sliding panel until a clicking sound indi-

cates that the headset is locked in place.