Jensen CD6111 User Manual

CD6111

7

Press BAND (13) during radio play to switch between three FM bands and one AM band. “F1”, 
“F2”, “F3” or “AM” will appear in the display to indicate the band currently selected.

Press the Up Tuning (14a) button to tune upward in frequency and the Down Tuning (14b) 
button to tune downward in frequency. The unit will automatically stop at the next strong 
station. If the Local mode is active, the radio will seek the next strong local station when either 
button is pressed.

Press the Up Tuning (14a) or Down Tuning (14b) button for more than two seconds to select 
manual tuning mode. “MANUAL” will appear in the display. Press the Up or Down Tuning 
buttons  to move radio frequency up or down two digits at a time. Press and hold the Up or 
Down tuning buttons to quickly advance to a certain frequency. Release when the desired 
frequency is reached. If tuning is not adjusted within five seconds of entering manual tuning 
mode, the radio will revert to automatic tuning and “AUTO” will appear in the display.

Press SCAN (15) to scan upwards through all the strong channels in the current band. The unit 
will pause and play each station for five seconds, and the station frequency will flash in the 
display during this time. Press SCAN again to stop scanning and listen to the current station.

Up to six stations on each band can be stored as presets and can then be instantly recalled by 
pressing the associated preset button (16). To store a station, turn the radio on and select the 
desired band and station. Press and hold the desired preset button (numbered one through six 
on the face of the radio) for more than two seconds. When stored, the preset number will 
appear in the display. The station is now stored and can be re-called at any time by pressing 
the corresponding preset button. Repeat for the remaining five presets on the current band and 
for all presets on the other three bands.

Select six strong stations and store them in the current band using the Automatic Store feature. 
To enable this feature, press and hold AS/PS (17) for more than two seconds. The radio will 
automatically scan the band in use and enter strong stations into the preset memory positions 
for that band. After entering the stations into memory, the unit will automatically stop at each 
station for five seconds so each can be heard. When using the Automatically Store feature, the 
new stations replace any stations already stored in preset memory for the selected band.

Press AS/PS (17) to scan the six preset stations in the current band. The unit will stop at each 
station for five seconds before continuing to the next preset station, and the preset number will 
flash on the display during the preset scan. Press AS/PS again to stop scanning and listen to 
the current station.

Press MONO (18) during FM radio operation to select stereo reception of the broadcast signal. 
Under normal reception, the unit should be left in the stereo mode as indicated by the “ST” 
designation and the associated signal strength indicator that appear on the display panel when 
tuned to an FM stereo signal. If the signal is too noisy for comfortable listening, press MONO to 
switch to mono reception, and the “ST” indication will disappear. Press MONO again to return 
to stereo mode.

The equalizer function applies preset sound effects to the unit’s audio output signal. Press iEQ 
(20) to activate one of the following operating modes: FLAT, CLASSICS, POP M, ROCK M or 
DSP OFF. When the equalizer function is activated, the most recently selected bass/treble 
levels are ignored. If the bass and/or treble levels are adjusted while the equalizer function is 
active, the equalizer function will revert to FLAT. When the equalizer function is not active, the 
unit will return to the most recently selected bass and treble levels.