Kenwood TS590SG User Manual
7
GETTING ACQUAINTED 2
—— A ——
While receiving, the meter serves as an S-meter to
measure and display the received signal strength.
While transmitting, it serves as a power meter plus an
ALC meter, an SWR meter, or a Speech Processor
compression meter. While adjusting the IF fi lter
bandwidth, the meter displays an adjustment state
{page 12}.
measure and display the received signal strength.
While transmitting, it serves as a power meter plus an
ALC meter, an SWR meter, or a Speech Processor
compression meter. While adjusting the IF fi lter
bandwidth, the meter displays an adjustment state
{page 12}.
—— B ——
Appears when the Auto Mode function is ON and
while in Auto Mode frequency setup {page 53}.
while in Auto Mode frequency setup {page 53}.
Displays the operating mode (USB, LSB, FM, AM,
CW, CWR, FSK, or FSR) {page 11}.
CW, CWR, FSK, or FSR) {page 11}.
Appears while in Menu mode {page 14}.
Appears while in Memory Scroll mode {page 44}.
Appears while in Memory Channel mode or Memory
Scroll mode {page 44}.
Scroll mode {page 44}.
In normal operating mode and various confi guration
modes, it displays the Memory Channel number,
Quick Memory number, and entry log number. In
Menu mode, it displays the Menu No.
modes, it displays the Memory Channel number,
Quick Memory number, and entry log number. In
Menu mode, it displays the Menu No.
—— C ——
Appears while in Data mode {page 11} and while in
Morse Code Decoder mode {page 38}.
Morse Code Decoder mode {page 38}.
Appears while in narrow FM mode {page 11}.
Appears when the receiver pre-amplifi er is ON {page
42}.
42}.
Appears when the receiver’s attenuator is ON {page
42}.
42}.
Appears when the Noise Blanker 1 or 2 is ON
{page 42}.
{page 42}.
“
” (fast) or “
” (slow) appears when the
Automatic Gain Control function is ON. “
”
appears when the AGC is OFF {page 30}.
Appears when IF fi lter A is selected {page 40}.
Appears when IF fi lter B is selected {page 40}.
—— D ——
“
” appears when manual notch is set to Normal.
“
” appears when Manual Notch is set to Wide.
“
” appears when Auto Notch is selected {page
41}.
Appears when the Fine Tuning function is ON {page
30}.
30}.
Appears when the MHz Step function is ON {page 29}.
Also appears when the Quick Menu function is ON
{page 14}.
Also appears when the Quick Menu function is ON
{page 14}.
“
” or “
” appears, depending on whether
DSP Noise Reduction 1 or Noise Reduction 2 is
selected {page 41}.
selected {page 41}.
“
” appears when the RX Equalizer function is ON
{page 57}. “
” appears when the TX Equalizer
function is ON {page 33}.
“
” or “
” appears, when you select the DSP
Beat Cancel 1 or Beat Cancel 2 {page 41}.
“ ” appears when the Tone function is ON {page 26},
and blinks during Tone scan. “
and blinks during Tone scan. “
” appears when the
CTCSS (Continuous Tone Coded Squelch System)
function is ON, and blinks during CTCSS scan {page
27}. “
function is ON, and blinks during CTCSS scan {page
27}. “
” appears when the Cross Tone function is
ON {page 28}.
LCD DISPLAY
A
B
C
D
E
F