Speco Technologies CVCM6DC Leaflet

 
 
 
 

This is a 12V DC camera – to 
avoid damage please observe 
polarity. 

 Gently pull the inner liner away from the dome cover. 

Carefully turn the dome cover counterclockwise 

to unlock and pull it free from the housing, then set 
both aside. 
 

Remove EZ Mount Plate from 

bottom of camera by turning 
counterclockwise. 
2.

 Determine if the connection wires 

will exit from the bottom or side of 
the base. 
3.

 If wires are going through the side, 

carefully remove the wire clearance 
tab on the side of the base. 
4.

 Mark holes for mount position as 

required. 
5.

 Attach plate to the mounting 

surface using anchors and screws 
supplied. 
6.

 Feed the connectors into the wire 

hole and align holes in camera base 
with EZ mount plate studs. 
7.

 Slip base over studs, gently press 

base against the mounting surface 
and rotate until the base locks in 
place.  
8.

 If not using EZ Mount Plate, slip 

base over screws, press base 
against the mounting surface and 
rotate until the base locks in place. 
Tighten screws until base is firmly 
held but do not over tighten.  

Attach BNC connector from camera 

to a BNC(male) connector on your 
video cable. 
2. 

IF using a plug-in power supply with 

attached connector, verify that the 
center pin is the plus (+) wire and 
the outer shell is the negative 
(-) wire. 
3. 

IF extending power wire from a 

remote power supply, verify polarity on 
feed from power supply. Connect 
positive (+) wire to red wire from pigtail 
supplied and attach negative (-) wire to 
black wire from pigtail. Verify that the 
center pin of pigtail connector is 
positive (+) before connecting to 
the camera. 
4.

 Connect to power supply

. 

Use a soft, lint free cloth to wipe the 

dome cover and remove finger prints.

The dome cover may be replaced with 

or without the liner. 
3.

 If lighting is coming from behind the 

camera, use the dome liner to hide the 
camera position.  
4.

 Before inserting the liner note the 

position of the camera lens so the lens 
will be placed at the opening of the liner 
when the dome is locked in. 
5

. Align the dome cover tabs with the 

slots in the base, gently press the cover 
into the slots and rotate clockwise until it 
is secure and the dome liner opening is 
aligned with the camera lens. 
 

 Depending on the 

material of your mounting 
surface, you may require 
different screws and anchors 
than those supplied. 

Use these adjustments to align the 
camera position to obtain the image 
desired.

 

1 

2 

2 

3

4

5

05.30.08