Intel 05-2065-002 User Manual

Page of 48
16
IP Media Server (Global Call) Demo Guide — November 2003
Preparing to Run the Demo
Quality of Service
The application can set threshold values to monitor the quality of service during calls. A fault 
occurs when the result of a measurement of a QoS parameter crossed a predefined threshold. A 
success occurs when the result of a measurement of a QoS parameter did not cross a 
predefined threshold. The QoS parameters are measured during time intervals, starting when a 
call is established. The following parameters are supported:
MediaAlarmLostPackets – monitors the number of lost IP packets during a call
MediaAlarmJitter – monitors the jitter (as defined in RFC 1889) during IP transmission
QoS Attributes
The threshold for each QoS parameter is measured with the following six attributes:
Threshold – defines when a QoS parameter is in a fault condition. A fault occurs when the 
result of a measurement of a QoS parameter crossed the Threshold value.
DebounceOn – the time during which faults are measured (in msec., must be multiple of 
Interval)
DebounceOff – the time during which successes are measured (in msec., must be multiple 
of Interval)
Interval  – the amount of time between two QoS parameter measurements (in multiples of 
100 msec)
Percent_Fail  – used to detect failure condition, together with DebounceOn (expressed as 
a percentage of failures)
Percent_Success – used to detect failure recovery, together with DebounceOff (expressed 
as a percentage of successes)
The default values are as follows:
Sample Configuration File
################################################################################################
# IP Protocol :
#
The IP Protocol used for
opening the IP Line devices, values: H323, SIP, both
#
# DTMFmode
#possible options:
#OutOfBand, inband, rfc2833
#
# Capability posiblities:
#
g711Alaw
#
g711Mulaw
#
gsm
#
gsmEFR
#
g723_5_3k
#
g723_6_3k
#
g729a
#
g729ab
#
t38UDPFax
#
#
Note: if you want to run the demo with coder g729 use:
#
g729a for running with VAD disable
#
and 729ab for running with VAD enable
#
# Caution:
Threshold
DebounceOn
DebounceOff
Interval
Percent_
Fail
Percent_
Success
Lost packets
20
10000
10000
1000
60
40
Jitter
60
20000
60000
5000
60
40