Lucent Technologies 8.2 User Manual

Issue 1

April 2000

Screen reference 

601

DS1 Circuit Pack 

This display-only field shows the port address specified in the 

 command 

when the circuit pack was first administered.

Use this field to assign a significant, descriptive name to the DS1 link. Lucent 
recommends putting the vendor’s circuit ID for the link in this field, because that 
information helps you troubleshoot problems with the link, but you could also use 
this field to indicate the function or the destination of this DS1 facility. In that 
case, put the DS1 link circuit ID in the Name field of the trunk group associated 
with this link.

Use this field to select the maximum transmission rate for DS1 circuit packs that 
support either T-1 or E-1 service. For circuit packs that only support one of these 
services, the field is a display-only field.

Once an 

 operation is complete (that is, the DS1 screen has been 

submitted) you can’t change the Bit Rate field with a 

 

 

command. Instead, execute a 

 command. Then use the 

 

command to administer the circuit pack again. You’ll have to re-enter all the 
information for the circuit pack.

1–15 characters

Enter a name for the DS1 link. 

 add ds1 xxxxxx

Page 1 of 2

DS1 CIRCUIT PACK

  
              Location: 01A13

 Name: _______________

              Bit Rate: 2.048

 Line Coding: cmi

Signaling Mode: CAS

Interconnect: pbx

 

Country Protocol: 3 

Interface Companding: mulaw 

Idle Code: 11111111

MAINTENANCE PARAMETERS

  
        Slip Detection? n