Lucent Technologies Release 7 User Manual

Page of 2657
DEFINITY Enterprise Communications Server Release 7 
Maintenance for R7r  
555-230-126  
Issue 4
June 1999
Maintenance Object Repair Procedures 
9-907
HYB-LINE (Hybrid Line) 
9
HYB-LINE (Hybrid Line)
Hybrid Line is another term for the Multi-Function Analog Telephone (MFAT). The 
Hybrid Line set is also known as an SCS (Small Communications System).
The TN762B Hybrid Line circuit pack supports eight of these multifunction 
analog telephone sets. The Hybrid Line sets use three pairs of wires: an analog 
voice pair, a transmit/receive pair, and a power pair.
This section describes HYB-LINE (Hybrid Line) maintenance. HYB-LINE 
maintenance is closely related to, and sometimes interacts with, HYB-BD (Hybrid 
Line circuit pack) maintenance. This interaction should be kept in mind when 
troubleshooting Hybrid Line problems.
This section occasionally refers to a station’s service state. These service states 
are defined as follows:
Use status station to determine terminal service state. Status is reported as 
either out-of-service, in-service, or disconnect. The latter is equivalent to the 
ready-for-service state.
MO Name (in 
Alarm Log)
Alarm Level
Initial Command to Run
1
1.
UU is the universal cabinet number (1 for PPN, 2 - 44 for EPN s). C is the carrier designation 
(A, B, C, D, or E). SS is the number of the slot in which the circuit pack resides (01 to 21). pp 
is the two digit port number (01, 02, ...).
Full Name of MO
HYB-LINE
Minor
test port UUCSSpp l
Hybrid Line
HYB-LINE
Warning
test port UUCSSpp l
Hybrid Line
Out-of-Service
The port, and thus the station, have been removed from 
service. A busyout of a port will cause it to be 
out-of-service.
Ready-for-Service
The port on the circuit pack has been put into service, 
but the voice terminal has not yet established signaling 
communications with the port.
In-Service
The voice terminal has established signaling 
communications with the port, and the system is ready 
to process calls to and from that station. A terminal in 
the ready-for-service state will progress to the 
in-service state if it is functioning normally, but it can 
also be forced into the in-service state if it goes 
off-hook.