Lucent Technologies Release 7 User Manual
DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1633
TAPE
9
Replacing the TAPE Circuit Pack
For a Simplex SPE:
a. Enter busyout host-adapter. The Host Adapter should be "busied out" to
prevent other applications from trying to access the tape or the disk. The
Tape circuit pack supplies +12V to the Disk circuit pack so when it is
removed, the Disk circuit pack will also go out of service.
Tape circuit pack supplies +12V to the Disk circuit pack so when it is
removed, the Disk circuit pack will also go out of service.
b. Replace the Tape circuit pack and insert the tape cartridge into the new
Tape circuit pack.
c. Issue the reset host-adapter command. This may take up to 3 minutes to
complete since it waits for the tape to retension.
d. Issue the release host-adapter command.
e. Issue the status spe command and check that the status screen indicates
that the tape and disk are now in service.
For a Duplicated SPE:
a. See
in Chapter 5.
b. After the standby SPE is powered up and fully refreshed, test the standby
tape using the test tape long command.
Error Log Entries and Test to Clear Values
Table 9-616.
TAPE Error Log Entries
Error
Type
Aux
Data
1
Associated Test
Alarm
Level
On/Off
Board
Test to Clear Value
1 (a)
any
Tape Reset (#894)
MINOR
OFF
reset tape a|b
18 (b)
0
Busyout Tape (#817)
WARNING
OFF
release tape a|b
250 (c)
0
Reset Tape (#894)
WARNING
OFF
reset tape a|b
257 (d)
any
Tape Looparound
(#814)
(#814)
WARNING
OFF
test tape a|b
sh rep 2
513 (e)
any
Tape Diagnostics
(#813)
(#813)
MINOR
ON
test tape a|b
sh rep 2
526 (f)
0
Busyout Host-adapter
WARNING
OFF
release host-adptr a|b
529 (g)
0
WARNING
OFF
reset tape a|b
769 (h)
any
Tape Looparound
(#814)
(#814)
MINOR
ON
test tape a|b
sh rep 2
Continued on next page