Planar PE190 User Manual
3
Interface for Arm Applications
Before installing to mounting device, please refer to Fig.1-2.
The rear of this LCD display has four integrated 4 mm, 0.7 pitches
threaded nuts, as well as four 5 mm access holes in the plastic covering
as illustrated in Figure 1-3. These specifications meet the VESA Flat
Panel Monitor Physical Mounting Interface Standard (paragraphs
2.1 and 2.1.3, version 1, dated 13 November 1997).
The rear of this LCD display has four integrated 4 mm, 0.7 pitches
threaded nuts, as well as four 5 mm access holes in the plastic covering
as illustrated in Figure 1-3. These specifications meet the VESA Flat
Panel Monitor Physical Mounting Interface Standard (paragraphs
2.1 and 2.1.3, version 1, dated 13 November 1997).
Note :Please using Ø 4mm x 8mm (L) screw for this application.
Figure 1-3
Cable Installation
Please follow these instructions to install the cables.
1.
Remove the back panel n from the rear of the monitor.(See Fig.
1-4)
1-4)
2.
Place the signal cable, the AC power cable into their correct
Socket.
Socket.
Figure 1-4
Connecting the Display to your Computer
1.
Power off your computer.
2.
Connect one end of the signal cable to the LCD Monitor’s VGA port
(See Fig 1-5)
(See Fig 1-5)
3.
Connect the other end of the signal cable to the VGA port on your
PC.
PC.
4.
Make sure connection are secure.
Figure 1-5
Attention
This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core
interface cable is included in the LCD Monitor package.
This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.
interface cable is included in the LCD Monitor package.
This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.
Connecting the AC Power
1.
Connect the power cord to the AC socket.(See Fig. 1-6)
2.
Connect the power cord to an AC power source.
Figure 1-6
Setting Up the LCD Monitor
1.
Turn on the LCD monitor’s hard power switch, located on the
back of the monitor (See Fig. 1-7)
back of the monitor (See Fig. 1-7)
2.
Turn on the LCD Monitor's soft power switch, located on the
bezel of the monitor.
bezel of the monitor.
Figure 1-7