Woods Equipment S106-3 User Manual
4 Introduction
29977 (Rev. 11/23/2009)
SPECIFICATIONS
GENERAL INFORMATION
Some illustrations in this manual show the cut-
ter with safety shields removed to provide a better
view. The cutter should never be operated with any
safety shielding removed.
view. The cutter should never be operated with any
safety shielding removed.
The purpose of this manual is to assist you in operating
and maintaining your cutter. Read it carefully. It fur-
nishes information and instructions that will help you
achieve years of dependable performance. These
instructions have been compiled from extensive field
experience and engineering data. Some information
may be general in nature due to unknown and varying
and maintaining your cutter. Read it carefully. It fur-
nishes information and instructions that will help you
achieve years of dependable performance. These
instructions have been compiled from extensive field
experience and engineering data. Some information
may be general in nature due to unknown and varying
operating conditions. However, through experience
and these instructions, you should be able to develop
procedures suitable to your particular situation.
and these instructions, you should be able to develop
procedures suitable to your particular situation.
The illustrations and data used in this manual were cur-
rent at the time of printing, but due to possible inline
production changes, your machine may vary slightly in
detail. We reserve the right to redesign and change the
machines as may be necessary without notification.
rent at the time of printing, but due to possible inline
production changes, your machine may vary slightly in
detail. We reserve the right to redesign and change the
machines as may be necessary without notification.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation is clockwise as viewed from the
top of the cutter.
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation is clockwise as viewed from the
top of the cutter.
S105
S105Q
S106
S106Q
Cutting Width
60"
60"
72"
72"
PTO Speed (rpm)
540
1000
540
1000
Blade Tip Speed (feet per minute)
11,451
14,137
10,178
12,566
Minimum Tractor Weight Recommended
4000 lbs
4000 lbs
5000 lbs
5000 lbs
Minimum Tractor HP Recommended
40 HP
40 HP
50 HP
50 HP
Minimum 3-Point Lift Capacity
2500 lbs
2500 lbs
3000 lbs
3000 lbs
Cutting Height (Depending on 3-point hitch height) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1/2" - 12"
3-Point Hitch (Category 1 pins are available) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Category 2
Offset from Centerline Tractor PTO to Inside Edge of Cut (Approximate) . . . . . . . . . . . . . . . . . . . . . . . . . . . 63"
Transport Width from Centerline PTO to Right Side with Head Raised (Approximate) . . . . . . . . . . . . . . . . . 70"
WARNING