Little Wonder 3/1/2000 User Manual

To prevent possible explosion or ignition of vaporized 

fuel, do not store equipment with fuel in tank or 

carburetor in an enclosure with open flame (for example, 

a furnace or water heater pilot).

  1.  Drain all fuel from the fuel tank and fuel lines. 

  2.  Start the engine and run until all the fuel is used 

from the carburetor float bowl and the engine 

stops.

  3.  While the engine is still warm, drain the crankcase 

oil and replace with the proper weight oil 

corresponding to the season the equipment will be 

next used.

 4.  Remove the spark plug and squirt a small amount 

of engine oil into the cylinder.  Slowly pull the 

starter a few times to distribute oil in the cylinder 

and reinstall the spark plug.

 5.  Top off if necessary.  See engine manual for 

details.

Location

Description

P/N

Min. Torque 

Ft-lbs (In-lbs)

Max. Torque 

Ft-lbs (In-lbs)

Housing to engine face

BLT-W LF 5/16-24 x 1-3/8

910517

22

28

Engine to deck

BLT 5/16-18 X 1-1/2

64262-009

19

25

Fan to Crankshaft

BLT-HEX 7/16-20 x 1-3/4 GR8

(USED ON 9270 MODELS)

64123-253

50

90

BLT-HEX 3/8-24X1-3/4 GR8

(USED ON 9390 AND 9400 

MODELS)

64123-127

30

50

BLT-HEX 3/8-24 X 2.5 GR 8

(USED ON 9570 MODELS)

64123-267

30

50

  1.  Check for loose parts and tighten if necessary. 

  2.  Fill the fuel tank and then check the engine oil 

level.

  3.  Start the engine and check for fuel leaks.  Repair 

any leaks before operating the unit.