FMI PDG18 Leaflet

Figure 1 - Removing Log Set

Figure 2 - Installing Replacement Log Set

Save these instructions for future reference

REPLACEMENT LOG SET

INSTALLATION INSTRUCTIONS

FOR BTB18, BTB24, PDG18 AND PDG24 GAS LOG HEATERS

WARNING: If log set has been in use, make sure

control knob is in the OFF position, unit is cold and

gas has been turned off.

Part No. Description Qty.
111835-01
111834-01
111827-01
111802-01
111817-08
111824-01

Your replacement kit will contain only one log set assembly depend-

ing on your model. If there is a problem with your replacement log

set contact the authorized dealer where you bought the set or FMI

PRODUCTS, LLC at 1-866-4537.

Items Needed for Installation:

•

5/16'' Hex Socket Wrench or Nut Driver

•

Phillips Screwdriver

•

5/8'' Wrench or Adjustable Wrench

1. Remove six screws from sides of log set assembly (three on

each side). Remove log set assembly (see Figure 1). Do not

pull on log assembly to remove. Work log set off chassis by

manipulating metal base.

2. 18'' models only: Disconnect flexible gas line from valve and

burner (see Figure 1). Discard flex line.

1
1
1
1
1
2

Replacement Log Set 18'' - BTB18
Replacement Log Set 18'' - PDG18
Replacement Log Set 24'' - BTB24
Replacement Log Set 24'' - PDG24
Flex Tube
Compression Nut/Sleeve

24" Set

18" Set

Bracket

Chassis

Disconnect

Flexible Gas Line

24" Set

18" Set

3. Place new log set assembly over chassis and align holes on

bracket with holes on chassis (see Figure 2).

4. Replace six screws removed in step 1.