HTC Z4824 User Manual

English

-48

MAINTENANCE

Anti-scalp rollers are properly adjusted when they are 

just slightly off of the ground when the deck is at the 

desired cutting height in the operating position. Anti-

scalp rollers then keep the deck in the proper position 

to help prevent scalping in most terrain conditions.

CZ-9

The gauge wheels can be set in three positions:

•

Upper position 1½ to 3" (38 to 76 mm) grass.

•

Middle position 3" to 4½" (76 to 114 mm) grass.

•

Lower position 4½" to 6" (114 to 152 mm) grass.

The rollers should be approximately ¼" (6.5 mm) from 

ground. Do not adjust the rollers to support the deck.
1.   Adjust the deck to the desired cutting height (see 

“TO ADJUST DECK CUTTING HEIGHT” in the 

operation section of this manual).

2.  Using a ¾" wrench and a 

9

/

16

" wrench, remove the 

nut and shoulder bolt from the gauge wheel.

3.   Lower the gauge wheel to the ground, and raise it 

up to the next highest hole.

4.   Replace and tighten the nut and shoulder bolt.
5.   All of the gauge wheels should be adjusted to the 

same position.

6.   Readjust the gauge wheels if the cutting height is 

changed.