Cal Flame Portable Spa User Manual

Page of 52
2009 Portable Spa
LTR20091000, Rev. A
Operating 
Your Spa
www.calspas.com
12
Auxiliary Control 
Operation
The auxiliary control option is available with the 9800 
controls only. It is a small panel with four buttons 
that control certain spa functions, such as primary 
or  additional  jets,  TV,  or  lights.  It  conveniently 
puts  the  control  of  several  spa  functions  at  your 
fingertips without having to get up.
Auxiliary Panel 
Configuration
Functions
Standard 
configuration 
JETS 1, JETS 2, LIGHT, 
OPTION
Spa models with 
automatic TV
JETS 1, JETS 2, TV, 
OPTION
Spa models with 
3-pump system
JETS 1, JETS 2, JETS 3, 
OPTION
until  the  set  temperature  is  changed 
as described below.
These  instructions  will  describe  fea-
tures and options that your particular 
spa may not be equipped with.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 
40°C)
The  start-up  temperature  is  set  at 
100°F  (37.5°C).  The  last  measured 
temperature  is  constantly  displayed  on  the  control 
panel. Note that the last measured spa temperature is 
displayed. The displayed temperature will be updated 
when  the  pump  has  been  running  for  at  least  two 
minutes.
Press the “UP” or “DOWN” buttons once to display the 
set  temperature.  Each  time  either  button  is  pressed 
again, the set temperature will increase or decrease 
depending  on  which  button  is  pressed.  After  three 
seconds,  the  control  panel  will  automatically  display 
the last measured spa temperature.
Time
When time hasn’t been programmed, the “TIME” icon 
flashes. To set the time, press the “TIME” button and 
then  the  “MODE/PROG”  button.  Use  the  “UP”  and 
“DOWN” buttons to adjust time.  See the next page 
for more detailed instructions. 
Standard, Economy, Sleep, and Standby 
Modes
Mode/Prog: This button is used to switch between 
standard, economy, and sleep modes.
Press 
“MODE/PROG” 
to 
enter 
mode 
1. 
programming.
Press the “DOWN” button to cycle through to the 
2. 
desired mode.
Press “MODE/PROG” to confirm selection.
3. 
9800 Electronic Control Operation
Initial Start up
When first powered up, your spa will perform a self-diagnostic check and to into priming mode. The topside will 
display PR to indicate this. Priming mode will be active for less than five minutes. When the spa has finished 
priming, the heater will be activated and the water temperature will be maintained in standard mode.  The spa 
will heat to 100°F (37.5°C) at start up