Jacuzzi J - 480 User Manual

Page 12

4.  The electrical supply for this product must include a suitably rated 

switch or circuit breaker to open all ungrounded supply conductors to 

comply with Section 422-20 of the National Electrical Code/USA, 

ANSI/NFPA 70. The disconnecting means must be readily accessible 

to the spa’s occupant but installed at least 5 feet (1.5m) from spa 

water.

5.  The electrical circuit supplied for the spa must include a suitable 

ground fault circuit interrupter (GFCI) as required by NEC Article 

680-42/USA.

6.  To gain access to the spa’s power terminal block, remove the screws 

securing the cabinet panel on the side of the spa under the controls. 

Then remove the four door screws for the small access door on the 

control box (Figure A).

7.  Select the power supply entrance you want to use (Figure A) and 

remove the short cabinet panel from the front of the spa. Make sure 

to install a 3/4" electrical fitting and conduit through the large opening 

provided in the bottom of the control box so you can feed the cable 

through to the terminal block.

8.  Connect wires to the terminal block (Figures B-E, pages 13-15). ALL 

WIRES MUST BE SECURELY CONNECTED or equipment damage 

could result!

9.  Install control access box door and reinstall the cabinet side panels.

1.  J-1000™ Control Box

2.  Power Supply Entrance(s)

3.  Jet Pump #1

4.  Heater

5.  Spa Drain Valve

6.  Pump Drain Plugs(s)

7.  Jets Pump #2

8.  Filter/Circulation Pump

9.  Optional CD Ozonator 

(Purchase Separately)

10.  Factory Installed Ozone Injector

11.  J-1000 Control Panel