Jacuzzi J - 480 User Manual

Page 60

Auto-Heating mode is typically selected  

by customers in cold climates where heat 

up times are extended due to lower 

ambient temperatures. In this mode, 

water temperature is regulated by the set 

temperature which activates the heater 

automatically as needed. 

note: If you elect to use Auto-Heating, you can skip this 

section. Auto-Heating is the default spa setting.

1.  Press button B to enter the Heating  

Menu (Figure C). The menu appears 

with Auto-Heating selected. If you 

elect to use this mode, press the 

Splash button on the Quad Keypad. 

The display will confirm your 

selection and Figure D will be 

displayed.

2.  To exit the submenu, press button D to return to the “Settings 2” 

Menu.

Programmable heating mode is typically selected by customers in warm 

climates where heat up times are minimized due to higher ambient 

temperatures. In this mode, the water temperature is regulated by the set 

temperature only when a programmed heating cycle is running, unless in 

summer logic page 64.

1.  From the Heating Menu (Figure C), use the Quad Keypad Down 

button to select the programmable setting, then press the Splash 

button to enable selection. 

A. 

1.  You are allowed to have two separate  

programs in the programmable 

mode, you can elect to use both or 

just one. Press the Splash button to 

enter the submenus for “Program A” 

(Figure E).

HEATING

Auto-Heating

Press         to set

Select

A

Programmable

Auto-Heating

Figure C

24-hour Heating 

Enabled

Figure D

Figure E

PROGRAMMABLE

Program A

Press         to set

Select

B

Program B

A

Program A

A