Jacuzzi J - 480 User Manual

Page of 104
Page 74
J-400
16.0  error/Display messages
There are a number of unique functions designed into your Jacuzzi spa 
to protect it from damage and/or to aid in troubleshooting. When an error 
occurs the spa will notify you by showing the screen below and an error 
code next to it. Following is a listing of all the possible messages along 
with their meanings:
1. 
Overheat protection: (Heater is deactivated, filter/circulation pump is 
activated). Water temperature is above acceptable limits. 
DO nOT 
enTer THe waTer! Remove spa cover to speed cooling. See 
“Water Is Too Hot” on page 79. If condition persists, contact your 
authorized dealer or authorized service center.
2.  Water is below set-temp: If the spa water is more than 20°F/6°C 
cooler than the temperature set point, the circulation pump and 
heater will automatically activate to provide freeze protection. The 
spa will stay in this mode until the water temperature reaches 
15 degrees below the set temperature. No corrective action is 
necessary.
3.  Communication error: Communication between the control panel and 
circuit board is faulty. If condition persists, contact your authorized 
dealer or service organization.
4.  Pump does not operate: Proper flow of water is inhibited or a flow 
switch has malfunctioned. Check for proper water level and for 
clogged filter (page 67). If no sound is detected or if a “buzzing” 
sound is detected, turn off power to the hot tub. Pump may not be 
properly primed. If condition persists, contact your authorized dealer 
or service organization.
5.  Freeze protection: A potential freeze condition has been detected. No 
action is required. Jets pump(s) and heater operate until the spa is out 
of danger. Depending on the amperage provided, operation will be as 
follows:
In 60A or 20A (50Hz only) logic, the heater remains on at all 
• 
times, while pump 1 and pump 2 turn on for 10 minutes and then 
off for 10 minutes. The pumps will alternate on and off until the 
spa gets out of the freeze condition.
98
F
Temp.
4:05 PM
!
“Displays 
Error 
Message”
warnInG:  rIsK OF HYPerTHermIa (OVer-HeaTInG) 
Causing severe inJury, burns, or welts.
!