SV Sound SX-VT User Manual

SX-ST / SX-SV User Manual 

page  9 

Replace the plastic side cover and tighten the screw. ( Do not over tighten ) 
 

NOTE:  

Certain D-Cells are longer than standard D-Cell batteries and slight difficulty may be found in 
closing the compartment if such batteries are used. Your nearest 

SONOSAX

 agent or the 

manufacturer in Switzerland can provide assistance if a problem arise due to this difference 
in length. 

 
Replace the battery compartment while holding in the slide-locks and make sure the power contacts are 
correctly positioned. The battery compartment is in place when the slide-locks return easily to their original 
position. 
 

 

 

 
 

An external NiCd or NiMH batteries charger is available for the SX-ST Series. (part nr SX 008415 ) 
You do not need to remove the cells from the battery tray to individually recharge the batteries.  
A connector located at the right side of the battery tray is provided to recharge all 12 cells at once. Simply 
remove the battery compartment as described at section 2.2.1 and connect appropriate charger to the battery 
pack. 
 

WARNINGS:  
- Never attempt to charge alkaline D-Cell batteries ( high risk of explosion ! ) 
- Charger must be suitable for 14,4 V batteries 
- Make sure that your NiCd or NiMh batteries accept high current charge when using a fast charger 

The 

SONOSAX SX-ST

 mixer can be powered from an external 10,5 to 18 Volts regulated DC power supply, 

capable of delivering at least 2.5A. The average power consumption is approximately 2A.

 

The 

SX-ST

 series is supplied with an auto-ranging power supply 100 to 240 VAC 50 or 60 Hertz, that can be 

used worldwide without modification or setting changes. 
 
The DC power supply input connector (XLR 4 pin, 

SONOSAX

 Part Number 

xxxxxxxx

) is located on the rear 

panel of the SX-ST mixer. Pin 1 is 0V or negative  / Pin 4 is positive +10,5 to +18VDC