Samson TXM20 User Manual

You can record the audio from the TXM16 and TXM20’s 

mixer section including the MIC, LINE, TAPE IN and AUX 

inputs to a cassette deck, MP3, MD, DAT or any other type 

of recorder using the record outputs.  Simply connect the 

TXM16 and TXM20’s CD 2/ TAPE OUT jacks to the input 

jacks of the recorder as shown in the diagram below. For 

playback, connect the recorder's outputs to the CD/TAPE 

input.

The TXM16 and TXM20’s MONO OUT can be used to 

drive a subwoofer system by engaging the SUBWOOFER 

ON/OFF switch located in the MONO output strip. When 

the SUBWOOFER ON/OFF switch is pressed in, the vari-

able Low Pass, (high-cut), filter is active. Now you can use 

the FREQUENCY control knob to set the high frequency 

limit of the MONO/SUBWOOFER OUT. The TXM mixer’s 

FREQUENCY control has a range from 20Hz to 200Hz 

allowing you to tune the output for a variety of subwoof-

ers. You can check your subwoofer’s owners manual for 

the manufacturers recommended cut off frequency, or 

use your ears while slowly sweeping the cut off point 

using the FREQUENCY control knob to find the correct 

setting for your system.

Connect the TXM16 or TXM20’s MONO OUT to the input 

of the power amp driving your subwoofer as illustrated in 

the drawing below.

ENGLISH

21