Stow MS15E User Manual

There is 1 set of drum bearing brackets (Figure 16) that will
require lubrication.  These brackets are intended to make
the drum rotate freely. Lubricate the grease fitting for each
drum bearing bracket 

becomes difficult to position using multi-purpose grade
grease.

There is 1 set of countershaft bearings  (Figure 17) that will
require lubrication. Lubricate the grease fitting for each
countershaft bearing 

every 40 hours of operation using

any grade lithium base grease.

There is 1 set of drum head seals (Figure 15) that will require
lubrication.

Failure to lubricate the  drum bearing grease fittings
periodically will cause the dumping mechanism to stiffen,
making the mixing drum hard to dump.

1.

There are two grease (Figure 18) fittings at each end of the
electric motor that will require lubrication. Lubricate these
fittings

 about every 16 months.

2.

Use Poleyrex EM (Exxon Mobil) or equalivant lubricant.
Clean grease fitting, apply grease gun to fitting (1/2 shot).
Remember too much grease or injecting grease too quickly
can cause premature bearing failure. Slowly apply the
recommended amount of grease, taking a miniute or so to
apply.

Failure to lubricate the  zerk grease grease fittings
periodically will cause the dumping mechanism to stiffen,
making the mixing drum hard to dump.

Grease seals every 

40 hours of operation using any grade

#1 lithium base grease. Apply grease until visible of mixing tub
(over grease). This will purge seal system of contamination.