Davis Instruments 6152C User Manual

Console Location

8

The console mounts to the wall using two keyholes located on the back of the case. 
To mount the console on a wall:
1. Use a ruler to mark two mounting hole positions on the wall 8 inches (203 mm) 

apart.

If installing a cabled Vantage Pro2 console with sensor cable running inside the 
wall, mount the console over an empty switch box. 

2. Use a drill and a 3/32 or 7/64''(2.5 mm) drill bit to drill two pilot holes for the 

screws.

3. Using a screwdriver, drive the two #6 x 1'' pan head self-threading screws into the 

wall. Leave at least 1/8'' (3 mm) between the wall and the heads of the screws.

4. If the kickstand has been pulled out from the case, push it back into its upright and 

locked position.

5. Guide the two keyholes on the back of the console over the two screws.

Drill two 3/32" or 7/64" (2.4 to 2.8mm) holes
8" (203mm) apart for the #6 x 1" mounting screws.

8" (203mm)