Tektronix AWG5000 Series User Manual

Interface and Display

AWG5000 Series Quick Start User Manual

Use the Settings window tabs to quickly access the Level (Ch 1, Ch 2, Ch 3, and Ch 4), Timing, Run Mode, Trigger, Event, 
or DC Output parameters. You can also use the front-panel buttons for selecting frequently accessed parameters, such as 
amplitude, offset, marker high/low, or sampling rate. See page 20 for details about accessing menus.

■

Each channel has independent output on/off control. When the output status of Ch n is set to On, both analog output and 
marker output are enabled.

■

When Direct Output is set to On, filter and offset settings become inactive. The analog bandwidth setting range will 
change.

■

You can use Add Input when Direct Output is set to Off. If Direct Output is selected, Add Input is disabled.

■

For Waveform Rotation, see page 62.

1. To enable a channel output, click the 

Output On button.

2. You can set parameters for amplitude, 

offset, filter, and marker.

3. You can add an external signal to each 

channel analog output.

4. Select Direct Output On and Off.

5. When the instrument is in the 

non-sequence mode, you can select the 
output waveform data using the Output 
Waveform field. Click the waveform list 
icon to display the Waveform List dialog 
box.

6. You can set phase shift or delay for 

each analog output signal when the 
instrument is in the non-sequence 
mode.