Anton/Bauer DUAL 2702 User Manual
3
SAFEGUARDS
Power Sources:
This unit was designed to operate at mains voltages from
90 to 250 Volts AC, 50-60 Hz.
90 to 250 Volts AC, 50-60 Hz.
Risk of Electrical Shock: Refer servicing to qualified service personnel.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
UNIT TO RAIN OR MOISTURE.
GROUNDING/EARTHING
IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED.
To ensure safe operation, the three pin plug supplied must be inserted only into a
standard three-pin power point which is effectively grounded through the normal
household wiring. Extension cords used with the equipment must be three-conductor
and be correctly wired to provide connection to earth ground. Improperly wired
extension cords are a dangerous electrical hazard.
standard three-pin power point which is effectively grounded through the normal
household wiring. Extension cords used with the equipment must be three-conductor
and be correctly wired to provide connection to earth ground. Improperly wired
extension cords are a dangerous electrical hazard.
The fact that the equipment operates satisfactorily does not imply that the power point is
properly grounded and that the installation is completely safe. If any doubt exists about
the correct grounding of the power point, consult a qualified electrician.
properly grounded and that the installation is completely safe. If any doubt exists about
the correct grounding of the power point, consult a qualified electrician.
IMPORTANT: The wires in this main lead are colored in accordance with the
following code:
Green and yellow
Earth
Blue Neutral
Brown Live
Brown Live
FUSE TYPE/REPLACEMENT
The mains input of the PowerCharger is fused using a printed circuit board
mounted device which should be replaced ONLY by a qualified service technician.
mounted device which should be replaced ONLY by a qualified service technician.
OPERATION
Self-Test
Upon applying mains power, each PowerCharger will initiate a self-test mode. This mode is
indicated in the LCD, by an audible alert and the lighting of each LED on the PowerCharger
in sequence. Upon completion of the self-test, the green status light will light steadily,
indicating that the unit is ready for operation.
indicated in the LCD, by an audible alert and the lighting of each LED on the PowerCharger
in sequence. Upon completion of the self-test, the green status light will light steadily,
indicating that the unit is ready for operation.
NOTE: Disconnect the camera cable from the 4 Pin XLR Connector located on the
back of the PowerCharger.
Software revision, power rating, and model number can be obtained from the Signature
Display. When the LCD shows the main display screen, press the TEST button on the
front panel.
Display. When the LCD shows the main display screen, press the TEST button on the
front panel.