Studer Innotec CFC-01 User Manual

10 Over 

Temp. 

For the time being 
the XP-COMPACT 
is out of service 
because of 
overheating. 

 

11 Overload 

The XP-COMPACT 
is out of service 
because of 
overload or short-
circuit 

 

12 

Batt. 

Low/High 

Battery voltage is 
too low 

Battery voltage is or was to high 

13 OFF 

XP-COMPACT is 
turned off. Turning 
it back on is only 
possible manually. 

XP-COMPACT is for the time being 
turned off. Turning it back on will 
follow automatically ! 

14 EQUALIZE 

Battery equalizing 
is set 

 

15–18  

State of charge of 
the battery 

LED 15 – Absorption time is running 

25 

POWER 

MONITOR 

Display the value of the output power in % of Pnom (in 
Inverter Mode) and the charge current in Amps (in Charger 
Mode). 

4.4 Push 

buttons 

19 ON/OFF 

Turning the XP-COMPACT on and off (Help Button for 
Programming) 

20 

RESET 

Alarm Signal off (Help Button for Programming) 

21 

Aux. Contact  Control Aux. contact (Help Button for Programming) 

4.5 Turning 

Knobs 

22 CHARGER 

Adjustment 

for 

max. Charging Current  

23 TRANSFER 

Adjustment for Transfer Voltage Threshold (TRANSFER – 
INVERTER) 

24 

STANDBY 

Adjustment for „Standby“ system 

4.6 The 

Inverter 

An Inverter is built in the XP-COMPACT, which generates a sinusoidal alternating 
voltage of a very high quality. With this Inverter any 230Vac alternating voltage 
appliance up to the nominal power of your XP-COMPACT can be operated. Thanks 
to the generous dimensioning of the XP-COMPACT, you can operate appliances 
requiring higher power than the nominal power of the XP-COMPACT for a short time. 
The XP-COMPACT provides up to 3-times the nominal power to start motors. 
The Inverter mode is displayed through LED 9 (Inverter). If the Inverter Mode is 
disabled (see chap. 5.5) LED 9 will blink. If the LED 9 is lit, the Inverter is in operation 
and you have 230Vac at the output AC OUT. The actual power of the connected 
appliance is displayed on the power monitor 25 and on the Remote Control.