Albatron Technology ARM11/Cortex-A8 User Manual
bdi
GDB
for GNU Debugger, BDI2000 (ARM11/Cortex-A8)
User Manual
42
© Copyright 1997-2007 by ABATRON AG Switzerland
V 1.04
3.3.5 Target serial I/O via BDI
A RS232 port of the target can be connected to the RS232 port of the BDI2000. This way it is possible
to access the target’s serial I/O via a TCP/IP channel. For example, you can connect a Telnet session
to the appropriate BDI2000 port. Connecting GDB to a GDB server (stub) running on the target
should also be possible.
to access the target’s serial I/O via a TCP/IP channel. For example, you can connect a Telnet session
to the appropriate BDI2000 port. Connecting GDB to a GDB server (stub) running on the target
should also be possible.
The configuration parameter "SIO" is used to enable this serial I/O routing.
The BDI asserts RTS and DTR when a TCP connection is established.
The BDI asserts RTS and DTR when a TCP connection is established.
[TARGET]
....
SIO
7
9600
;Enable SIO via TCP port 7 at 9600 baud
Warning!!!
Once SIO is enabled, connecting with the setup tool to update the firmware will fail. In this case either
disable SIO first or disconnect the BDI from the LAN while updating the firmware.
Once SIO is enabled, connecting with the setup tool to update the firmware will fail. In this case either
disable SIO first or disconnect the BDI from the LAN while updating the firmware.
Target System
Ethernet (10 BASE-T)
BDI
2000
AAAAbbbbaaaattttrrrroooonnnn AAAAGGG
G
SSSSwww
wiiiissssssss M
M
M
Maaaaddddeeee
ARM
RS232
RS232
POWER
LI TX RX 10 BASE-T
5
4
3
2
1
9
8
7
6
RS232 Connector
1 - CD
2 - RXD
3 - TXD
3 - TXD
4 - DTR
5 - GROUND
6 - DSR
7 - RTS
8 - CTS
9 - RI
7 - RTS
8 - CTS
9 - RI
XXX BDI Output