Albatron Technology ARM11/Cortex-A8 User Manual
bdi
GDB
for GNU Debugger, BDI2000 (ARM11/Cortex-A8)
User Manual
52
© Copyright 1997-2007 by ABATRON AG Switzerland
V 1.04
B Maintenance
The BDI needs no special maintenance. Clean the housing with a mild detergent only. Solvents such
as gasoline may damage it.
as gasoline may damage it.
If the BDI is connected correctly and it is still not responding, then the built in fuse might be damaged
(in cases where the device was used with wrong supply voltage or wrong polarity). To exchange the
fuse or to perform special initialization, please proceed according to the following steps:
(in cases where the device was used with wrong supply voltage or wrong polarity). To exchange the
fuse or to perform special initialization, please proceed according to the following steps:
Observe precautions for handling (Electrostatic sensitive device)
Unplug the cables before opening the cover.
Use exact fuse replacement (Microfuse MSF 1.6 AF).
!
1
2
3
BDI
2000
AAAAbbbb
aaaatttt
rrrroooo
nnnn
AAAAGGGG
SSSSwwww
iiiissss
ssss
MMMM
aaaadddd
eeee
1.1 Unplug the cables
BDI TRGT MODE BDI MAIN BDI OPTION
2.1 Remove the two plastic caps that cover the screws on target front side
2.2 Remove the two screws that hold the front panel
3.1 While holding the casing, remove the front panel and the red elastig sealing
(e.g. with a small knife)
front panel
elastic sealing
casing