Campbell Hausfeld IN633701AV User Manual

HU500000, HU502000

www.chpower.com

General Safety Information

(Continued)

SprayInG preCaUtIOnS

Do not

spray

flammable materials in
vicinity of open flame or near
ignition sources including the
compressor unit.

14. Do not smoke when spraying paint,

insecticides, or other flammable
substances.

15. Use a face mask /

respirator when spraying
and spray in a well
ventilated area to prevent
health and fire hazards.

16. Do not direct paint or other sprayed

material at the compressor. Locate
compressor as far away from
the spraying area as possible to
minimize overspray accumulation on
the compressor.

17. When spraying or cleaning with

solvents or toxic chemicals, follow
the instructions provided by the
chemical manufacturer.

WHeel aSSeMbly (Figures 3 and 4)
Wheel assembly kit includes:
  -  2 wheels *
  -  2 axle bolts *
  -  2 washers *
  -  2 nuts *
  -  2 wheel inserts *

The items marked with an asterisk (*)
were shipped loose with the unit.
1. Wheel has an offset hub. Place

wheel insert into center of hub. With
offset hub facing axle iron, assemble
axle bolt through washer and then
holes in wheel and axle iron.

2. Place lock washer on axle bolt. Then

tighten nut securely to threaded part
of axle bolt.

3. Repeat procedure with other side.

assembly

HanDle aSSeMbly (Figures 1 and 2)
1. Place ends of handle around tank

and into the mounting pipe. Align
holes in handle to holes in mounting
pipe.

2. Assemble four (4) screws (from parts

package) through holes in mounting
pipe and handle. Tighten screws.

Never use the

handle to lift the

unit completely off the ground. Only
use the handle to lift one end so the
wheels may be used to move the unit.

Figure 3 - Wheel assembly

(horizontal unit)

Nut

Wheel

Wheel Insert

Washer

Axle Bolt

Axle Iron

Figure 1 - Handle assembly

(horizontal unit)

Screws

Figure 2 - Handle assembly

(vertical unit)