Datalogic Scanning 1000 User Manual
GENERAL FEATURES
3
1
Electrical connection of Power, serial interfaces and I/O signals is provided through a
25-pin connector (see Figure A, 3). In addition there is a 9-pin Auxiliary interface
connector for reader configuration (see Figure A, 2).
The following indicators are located on the top of the reader:
25-pin connector (see Figure A, 3). In addition there is a 9-pin Auxiliary interface
connector for reader configuration (see Figure A, 2).
The following indicators are located on the top of the reader:
PWR
red LED indicates that the reader is connected to the power supply
(see Figure A, 7);
(see Figure A, 7);
TRIG
yellow LED indicates external trigger activity (Figure A, 6); for
details refer to par 2.3.4;
details refer to par 2.3.4;
READ
red LED signals successful code decoding (Figure A, 5).
It is also used to signal successful startup. At power on this LED
turns on and after a few seconds turns off. If the startup is not
successful, this LED remains on.
It is also used to signal successful startup. At power on this LED
turns on and after a few seconds turns off. If the startup is not
successful, this LED remains on.
COM
green LED indicates data transmission on the main serial interface
(Figure A, 4).
(Figure A, 4).