Datalogic Scanning QD2100 User Manual
Codabar
Product Reference Guide
223
Codabar — cont.
Codabar Set Length 1
This feature specifies one of the barcode lengths for
Codabar Length Control
. Length 1
is the minimum label length if in
Variable Length
Mode, or the first fixed length if in
Fixed Length
Mode. Length includes the barcode’s start, stop, check and data characters.
The length must include at least one data character.
The length can be set from 3 to 50 characters.
The length can be set from 3 to 50 characters.
Follow these instructions to set this feature:
1. Determine the desired character length (from 3 to 50). Pad the number with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
Mode.
3. Scan the barcode: SELECT CODABAR LENGTH 1 SETTING.
4. Scan the appropriate two digits from the keypad in
Appendix E, Keypad
, that represent
the length setting which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
cation after the last character.
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
Mode.
This completes the procedure. See
Table 29
for some examples of how to set this feature.
Table 29. Codabar Length 1 Setting Examples
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
abort and not save the entry string. You can then start again at the beginning.
STEP
ACTION
EXAMPLES
1
Desired Setting (and pad with
leading zeroes)
leading zeroes)
03 Characters
09 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODABAR LENGTH 1 SETTING
4
Scan Two Characters From
Appendix E, Keypad
‘0’ and ‘3’
‘0’ and ‘9’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE