HP (Hewlett-Packard) 2405 (Q3086A) User Manual

hp psc 2400 series

chapter 13

130

You must be available to respond in person to incoming fax calls, or your HP PSC 
cannot receive faxes. For information on how to receive fax calls manually from 
your attached phone and from an extension phone, see 

If you have a digital subscriber line (DSL) service through your phone company, 
use the instructions in this section to connect a DSL filter between the telephone 
wall jack and your HP PSC. This filter removes the digital signal that would block 
your HP PSC from communicating properly with the telephone line.

If you have a DSL line and you do not connect the DSL 

filter, you will not be able to send and receive faxes with your 
HP PSC.

First, connect your HP PSC according to the appropriate setup case for 
your office. For information, see 

Obtain a DSL filter from your DSL provider.

Using the phone cord supplied in the box with your HP PSC, connect one 
end to the open port on the DSL filter, then connect the other end to the 
port labeled “1-LINE” on the back of your HP PSC. 

While connecting your setup case, you might have already 

connected your HP PSC to the telephone wall jack using the HP-supplied 
cord. If so, remove this cord from the wall jack and connect it to the open 
port on the DSL filter.

If you do not use the supplied cord to connect from the 

DSL filter to your HP PSC, you might not be able to fax 
successfully. This special 2-wire cord is different from the more 
common 4-wire phone cords you might already have in your 
office. For more information about how to tell the difference 
between the cords, see 

Connect the DSL filter cord to the telephone wall jack.

Telephone
wall jack

Back view of the HP PSC

Use the phone cord 
supplied in the box with 
your HP PSC

DSL filter supplied 
by your DSL 
provider