Mentor v8.6_4 User Manual
FastScan and FlexTest Reference Manual, V8.6_4
2-506
Set Iddq Strobe
Command Dictionary
Set Iddq Strobe
Tools Supported: FastScan and FlexTest
Scope: All modes
Prerequisites: You must be fault simulating, or selecting from, an external pattern
source.
Usage
SET IDdq Strobe -Label | -All
Description
Specifies on which patterns (cycles) the tool will simulate IDDQ measurements.
The Set Iddq Strobe command affects stand-alone fault simulation as well as
pattern selection when you use the Select IDDQ Patterns command. Set IDDQ
Strobe determines whether the tool simulates only existing IDDQ measure
statements within an external pattern source or if it should assume that every
pattern (cycle) in the set has an IDDQ measure statement. The command performs
slightly differently depending on whether you are using FastScan or FlexTest. In
either case you can use the Report Environment command to list the current
setting. The following paragraphs describe how the Set Iddq Strobe command
operates for each tool.
pattern selection when you use the Select IDDQ Patterns command. Set IDDQ
Strobe determines whether the tool simulates only existing IDDQ measure
statements within an external pattern source or if it should assume that every
pattern (cycle) in the set has an IDDQ measure statement. The command performs
slightly differently depending on whether you are using FastScan or FlexTest. In
either case you can use the Report Environment command to list the current
setting. The following paragraphs describe how the Set Iddq Strobe command
operates for each tool.
FastScan Specifics
The Set Iddq Strobe command specifies which fault grading patterns will perform
IDDQ measures during simulation.
IDDQ measures during simulation.
FlexTest Specifics
The Set Iddq Strobe command specifies which test cycles will perform IDDQ
measures during simulation.
measures during simulation.
Arguments
•
-Label
This is the default behavior upon invocation of either tool.