Elo TouchSystems JH 15T05 User Manual

Physical Overview - MMC ETX

INB100014-1 (Rev 19)

IND100133-10

PCI Slots 1&2: (Not available on all models!)

Supports PCI (Short Length / Standard Profile) card in two available slots. These PCI cards are

normally installed from factory or returned to factory for upgrading if needed. Note that warranty

will be void if you install PCI cards yourselves. In order to mount PCI cards, the chassis of the unit

must be removed, thus making warranty void as the warranty sticker would have to be broken.

The PCI slots are not available on all MMC ETX models, due to space restrictions.

COM1,2,, Serial Ports INPUT/OUTPUT:

Supports RS232 / RS422 / RS485 using D-SUB 9P Male connectors. Fasten the cable to the

connector using the provided screws on the cable housing itself. (Factory default is RS232 only)

Network INPUT/OUTPUT:

Supports 10/100Mbps Ethernet (LAN) and 10/100/1000Mbps Ethernet (GBLAN). Suitable for

twisted pair cables CAT.5E. Make sure the network cable connector ”clicks” into the RJ-45

connector.

RGB OUTPUT:

Will output a clone signal from the computer for use with external display or monitor. Connects via

a High Density D-SUB 15P Female connector. Fasten the cable to the connector using the

provided screws on the cable housing itself.

LPT1 Parallel Port INPUT/OUTPUT:

Standard LPT1 Printer/Parallel (SPP/EPP/ECP) port using a D-SUB 25P Female connector.

Fasten the cable to the connector using the provided screws on the cable housing itself.

Connector area of computer

RGB OUT

Network GigaBitLAN & LAN

PCI SLOT 1

PCI SLOT 2

PS/2 Keyboard

Parallel (LPT)

COM4, COM2

COM3, COM1

PS/2 Mouse

USB 1,2,3

Compact Flash Reader

Power Input

NOTE: Available connectors / locations (may) vary depending on model !