Kenwood DDX4033BTM User Manual

English

•  Insulate unconnected wires with vinyl tape or 

other similar material. To prevent a short circuit, 
do not remove the caps on the ends of the 
unconnected wires or the terminals.

•  Connect the speaker wires correctly to the 

terminals to which they correspond. The unit may 
be damaged or fail to work if you share the 

· 

wires or ground them to any metal part in the car. 

•  When only two speakers are being connected 

to the system, connect the connectors either to 
both the front output terminals or to both the 
rear output terminals (do not use one from each). 
For example, if you connect the 

ª connector 

of the left speaker to a front output terminal, do 
not connect the 

· connector to a rear output 

terminal.

•  After the unit is installed, check whether the brake 

lamps, blinkers, wipers, etc. on the car are working 
properly.

•  Mount the unit so that the mounting angle is 30° 

or less.

•  Do not press hard on the panel surface when 

installing the unit to the vehicle. Otherwise scars, 
damage, or failure may result.

•  This unit has the cooling fan to decrease the 

internal temperature. Do not mount the unit 
in a place where the cooling fan of the unit is 
blocked. Blocking these openings will prevent the 
cooling of the internal temperature and result in 
malfunction.

Cooling fan

•  Install the Bluetooth adapter (KS-UBT1) besides 

the place enclosed by the metal.

Bluetooth adapter (KS-UBT1)

 DDX6033BT/DDX6033BTM/DDX6033 
only
Before installation, remove the screws
Use these screws when installing the unit 
(Same as Accessory 4).

¤ 

Install this unit in the console of your 
vehicle. 
Do not touch the metal part of this unit 
during and shortly after the use of the 
unit. Metal part such as the heat sink and 
enclosure become hot. 

EN_GET0908-001A_MX.indb   78

EN_GET0908-001A_MX.indb   78

12/11/13   11:46

12/11/13   11:46