Lenovo L2251p User Manual

 

 
 

 

This section describes the user control features used to adjust your monitor image. 

The direct access controls can be used when the On Screen Display (OSD) is not   
displayed. 

 

Note: The direct access controls are blue. 

 

Input Change 

Switches the video input source. 

 

Image Setup 

Activates automatic image adjustment. 

 

Brightness 

  Direct access to Brightness adjustment. 

 

The settings adjustable with the user controls are viewed through the On-Screen   
Display (OSD), as shown below. 

 
 
 
 
 
 
 
 
 
 
 
 
 

To use the controls: 
1.  Press 
2.  Use 

 or 

  to move among the icons. Select an icon and press 

 to access  

that function. If there is a sub-menu, you can move between options using 

   

or 

  , then press 

  to select that function. Use 

  or 

 to make adjustments.  

Press 

 to save. 

3.  Press 

  to move backwards through the sub-menus and exit from the OSD. 

4.  Press and hold 

  for 10 seconds to lock the OSD. This will prevent accidental   

adjustments to the OSD. Press and hold 

  for 10 seconds to unlock the OSD   

and allow adjustments to the OSD.   

5.  Enables DDC/CI by default. Use OSD Exit Key, press and hold the

  buttons for                 

CI/Enable" shows on the screen. 

 

 

 
 
  

 

Chapter 2. Adjusting and using your monitor   

 

 
 
 
 

 

 
 

 
 

press "AUTOSCAN" to go back to Auto Scan mode. 

 

"No sync","No Cable" or "power Saving Mode".press        or        to

 choose input signal. 

 
 
 
 
 
 
 
 
 
 
 
 
 

(picture 1)

(picture 2)

  to open the main OSD menu(picture 1). 

6.    Press "Exit Key" to enter the input Signal meun(picture 2) when the monitor

   

 is under

 the condition of

5 seconds to disable/enable DDC/CI function. The words " DDC/CI Disable/DDC/