Fujitsu IP-9610 User Manual

Chapter 5  Troubleshooting 

48

 

 

No.  Class Status 

Description Recommended 

action 

9.   

Is the power to the communication 

destination device turned on? 

Verify the power supply and operation of 

the communication destination device. 

10.   

The LINK/ACT 

LED for the 

LAN port is not 

turned on. 

Are the LINK LEDs on this device 

and the hub turned on? 

If the LINK LEDs are not ON, the LAN 

cable is not connected.    Connect the LAN 

cable correctly. 

11.   

Is the IP address specified from the 

Web browser correct? 

Specify a correct IP address    from the Web 

browser on the control terminal. 

12.   

Are the network settings (IP 

address, subnet mask, etc.) on the 

control terminal PC correct? 

Make correct settings by referring to the PC 

user's guide and OS handbook.    If this 

device is started with the default settings 

made before shipment from the factory, see 

"Section 3.4, " Special Use of CANCEL 

Key," for the network settings for the 

control terminal PC. 

13.   

Line 

Device setting 

through a LAN 

is disabled. 

Is a reply received in response to a 

PING command issued to the IP 

address of the device? 

If a reply is not received, turn on the power 

to the device while holding down the 

Cancel key to start the system with the 

default IP address (10.0.0.1) set before 

shipment from the factory.    Confirm the IP 

address.    If the problem persists, check the 

status on the LAN.    For information on 

this startup procedure, see Section 3.4, 

"Special Use of CANCEL Key."